Yamaha 303 - Manual (Page 203)

CVP-305/303/301 Owner’s Manual 203
Appendix
6
Connect the speaker cord.
1 Before connecting the speaker cord, remove the vinyl tie
attaching the speaker cord to the front panel.
2 Insert the speaker cord plug into the connector, with the
plug’s tab facing the rear.
7
Connect the pedal cord.
8
Attach the rear panel.
9
Set the voltage selector and connect the power
cord.
Voltage Selector
Before connecting the AC power cord, check the setting of the
voltage selector which is provided in some areas. To set the selector
for 110V, 127V, 220V or 240V main voltages, use a “minus”
screwdriver to rotate the selector dial so that the correct voltage for
your region appears next to the pointer on the panel. The voltage
selector is set at 240V when the unit is initially shipped.
After the proper voltage has been selected, connect the AC power
cord to the AC INLET and an AC wall outlet. A plug adaptor may be
also provided in some areas to match the pin configuration of the
AC wall outlets in your area.
WARNING
• An improper voltage setting can cause serious damage to
the Clavinova or result in improper operation.
10
Set the adjuster.
Rotate the adjuster until
it comes in firm contact
with the floor surface.
After completing the assembly, please check the
following.
1 Insert the pedal
cord plug into the
pedal connector.
2 Attach the
cord holders to
the side panel
as shown,
then clip the
cord into the
holders.
1 With the rear
panel on the
feet’s protruding
edge, align the
panel with the
groove and
secure the top
of the panel.
2 Secure the left and right corners using the
4x14mm thin screws.
3 Secure the top center and
bottom of the panel using the
4x20mm tapping screws.
240
127
110
220
• Are there any parts left over?
→ Review the assembly procedure and correct any
errors.
• Is the Clavinova clear of doors and other movable
fixtures?
→ Move the Clavinova to an appropriate location.
• Does the Clavinova make a rattling noise when you
shake it?
→ Tighten all screws.
• Does the pedal box rattle or give way when you
step on the pedals?
→ Turn the adjuster so that it is set firmly against the
floor.
• Are the pedal and power cords inserted securely
into the sockets?
→ Check the connection.
• If the main unit creaks or is otherwise unsteady
when you play on the keyboard, refer to the assem-
bly diagrams and retighten all screws.
When moving the instrument after assembly, always
hold instrument by the lower surface in the front of
the main unit and by the handles in the rear panel.
CAUTION
Do not hold the key cover or top portion. Improper handling
can result in damage to the instrument or personal injury.
Top portion
Key cover
Hold here.
Do not hold here. Do not hold
here.