Removing temporary escape character, Defining permanent escape character – Xerox 3270 User Manual
Page 13

3270 Programmer’s Guide
Function Selection via the Line
- 13 -
2.1.2. Removing Temporary Escape Character
If you wish to remove the temporary ESC character so that it may be
used as a printable character, you can define it as a blank as shown
below.
&&??
Removing the temporary ESC character .
2.1.3. Defining Permanent Escape Character
The paragraph "Defining a temporary ESC character ", only de-
scribed the temporary use of the ESC character .
If you wish to define and save a permanent ESC character in the
printer, you will have to use Function 48, Select Perma nent Escape
Character, and save the settings in the permanent memory by the
command
To program Function 48, a temporary escape character has to be
defined first.
You can define the permanent ESC character in two ways:
1. In hex value, e.g. %Y48,09%
2. In apostrophe notation, e.g. %Y48,'<'%
&&??%
Define temporary escape
%Y48,’<‘%
Define permanent escape
Store settings
NOTE:
If the character used in Function 48, Select Permanent
Escape Character, is different from the one specified
as temporary ESC character, the latest specified char-
acter will take precedence immediately.