Yamaha Drum Trigger Module DTXPLORER - Manual (Page 26)

26
V
elocity
m
Strength
of hit
m
*2 Rim1 and rim2 sounds on the [ TP1/SnrB ] are reversed from
those on [ TP1/SnrA ]. This provides left-handed drummers with
a proper setting when using a left-handed setting.
*3 When a stereo pad such as the TP80S is connected to the 1
SNARE input, [ TP2-A ] will produce the sound that is assigned
to rim 1, and [ TP2-B ] will produce the sound assigned to rim 2.
(Refer to P. 20)
*4 When an RHP series stereo pad is used, connect the pad to
Input 8/9 and set the pad type in Input 8 to [ RHP pad ] and the
pad type in Input 9 to [ RHP rim ].
*5 To use the BP80 as a stereo pad, connect the pad to Input 8/9.
TRIG3 Gain, MVI (Minimum Velocity)
Gain [Range] 0 to 99
Adjusts the input gain (sensitivity) for the input jack shown in the
upper half of the display.
Assigning a larger value lets a smaller input level from the pad
create sound.
* This value will be automatically set after the appropriate pad
type is set in [TRIG2 Pad (Pad Type)]. Some fine-tuning of the
value will be necessary.
* Some pads are equipped with a sensitivity adjustment knob.
Please refer to the Owner’s Manual that came with the pad for
further information.
MVl [Range] 1 to 127
Sets the MIDI Velocity (volume) that is transmitted when the pad
is hit the weakest. Large values will produce a high volume level
even if the pad is hit softly. However, this will result in a narrow
volume range making it difficult to adequately produce wider dy-
namic levels.
The trigger input level will be displayed as a % in the upper right
hand corner of the display. The maximum velocity (input level 99%)
will be 127. The level is low when the pad is hit the weakest so a
wider dynamic range will be possible.
* This value will be automatically set after the appropriate pad
type is set in [TRIG2 Pad (Pad Type)]. Some fine-tuning of the
value will be necessary.
Trigger Setup Edit
norm loud2 loud1 hard1 hard2
TRIG4 VelCurve (Velocity Curve)
Sets the Input Velocity Curve for the trigger input jack assigned in
the upper half of the display.
TRIG5 SelfRejTime (Self Rejection Time)
[Range] 0 to 9
Prevents double triggers from occuring in the input jack assigned
in the upper half of the display. After an event is detected, further
events will be automatically muted for a certain length of time.
Larger values set longer times.
TRIG6 Rejection (Rejection Level)
[Range] 0 to 9
Prevents cross talk from occuring in the input jack assigned in the
upper half of the display. Events triggered by other pads (input
jacks) that are of a lower input value than what is set here will not
be delivered for a set length of time.
TRIG6 ¡snare 0%
– Rejection=2 ‚
TRIG5 ¡snare 0%
–SelfRejTime=1 ‚
TRIG4 ¡snare 0%
–VelCurve=norm ‚
TRIG3 ¡snare 0%
–Gain=65MVl= a15‚