Yamaha DSP-Z9 - Manual (Page 34)

32
AUTO SETUP
For best results, make sure the room is as quiet as possible
during the auto setup procedure. If there is too much
ambient noise, the results may not be satisfactory.
y
If your subwoofer can adjust the output volume and crossover
frequency, set the volume to about half way (or slightly less), and
set the crossover frequency to the maximum.
1
Switch on the unit and video monitor, then
press TOP on the GUI remote control.
The TOP display appears.
2
Press k / n repeatedly to select Auto Setup,
then press h .
3
Press k / n repeatedly to select Setup Menu,
then press h .
4
Press k / n repeatedly to select Wiring,
Distance, Size, Equalizing or Level.
For Wiring, Distance, Size or Level, select:
Check To automatically check and adjust the selected
item.
Skip To skip the selected item and perform no
adjustments.
y
When using THX speakers, select Skip and make sure that
Small or Small x2 is selected in Speaker Set (page 67) and
that 80Hz (THX) is selected in Cross Over (page 69).
Starting the setup
TOP EXIT
ENTER
GUI remote control
ENTER ENTER
00EN.00_DSPZ9_GB.book Page 32 Thursday, November 13, 2003 10:55 AM