Yamaha DSP-Z9 - Manual (Page 30)

28
CONNECTIONS
If you are using 6-ohm speakers, set the impedance to 6
ohms as follows before turning on the power.
Be sure this unit is in the standby mode.
1
On the front panel, while holding down
SPEAKERS A, press STANDBY/ON.
“SP Imp. Set” appears on the front panel display for a
few seconds, then “Minimum 8ohms” appears.
2
Press SPEAKERS A or SPEAKERS B to
select the impedance of your speakers.
You can select either 6 ohms or 8 ohms.
3
Press STANDBY/ON to exit the setting.
This unit is set to the standby mode.
When all connections are complete, turn on this unit’s
power.
1
Press STANDBY/ON (SYSTEM POWER on the
remote controls) to turn on this unit’s power.
2
Turn on the video monitor connected to this
unit.
Speaker impedance setting
CAUTION
SPEAKERS
A
STANDBY
/ON
M i n i m u m A 8 o h m s
A S P A I m p . A S e t
Turning on the power
PHONO DVR
PURE DIRECT
2CH/MULTI CH SPEAKERS
VIDEO AUX
REC OUT/ZONE 2
INPUT MODE
SOURCE/REMOTE DVD DTV/LD MD/TAPE CD-R
CD TUNER
VIDEO AUX
VCR 2
VCR 1
SAT CABLE A B STRAIGHT
EFFECT
MULTI CH INPUT DSP PROGRAM
BALANCE
TONE CONTROL
VOLUME
INPUT SELECTOR
MULTI JOG
SILENT OPTIMIZER MIC
PHONES OPTICAL R AUDIO L VIDEO S VIDEO
STANDBY /ON
1
TRANSMIT RE-NAME
STANDBY TUNER
MULTI CH IN PURE DIRECT
TOP EXIT INPUT MODE
SOUND
SYSTEM
CLEAR LEARN MACRO OFF ON MACRO
PHONO
CD
DVD DVR VCR 2
TITLE
MENU
CHAPTER
PAUSE STOP POWER REC
STEREO AMP 10KEY HALL CHURCH JAZZ
SELECT
DISPLAY
SEARCH
SOURCE
PLAY
– +
ENTER
DTV/LD VCR 1
CD-R MD/TAPE SAT CABLE
POWER V-AUX 1
POWER
TOP EXIT
SYSTEM STANDBY
ENTER
1
STANDBY
/ON
SYSTEM
POWER
or
Front panel Remote controls
00EN.00_DSPZ9_GB.book Page 28 Thursday, November 13, 2003 10:55 AM