Connecting external power amplifiers, Connecting external preamplifiers, Connecting i.link components – Yamaha DSP-Z9 User Manual
Page 28
26
CONNECTIONS
■
Connecting external power amplifiers
If you want to increase the power output to the speakers,
or want to use another power amplifier, connect an
external amplifier to the pre out jacks.
• When RCA pin plugs are connected to the pre out jacks for
output to an external amplifier, it is not necessary to use the
corresponding SPEAKERS terminals. Set the volume of the
amplifier connected to this unit to the maximum.
• The signal output through the FRONT OUT, CENTER OUT
and SUBWOOFER jacks is affected by the TONE CONTROL
settings.
• Signals will only be output from the FRONT OUT jacks if
SPEAKERS B is set to “ZONE B” (see page 77) and
SPEAKERS A is turned off (see page 77).
1
FRONT OUT jacks
Front channel line output jacks.
2
CENTER OUT jack
Center channel line output jack.
3
SURROUND jacks
Surround channel line output jacks.
4
SURROUND BACK jacks
Surround back channel line output jacks.
5
PRESENCE jacks
Presence channel line output jacks.
6
SUBWOOFER jacks
Connect one or two subwoofer(s) with built-in amplifier,
such as the YAMAHA Active Servo Processing
Subwoofer System, to these jacks.
• Adjust the volume level of the subwoofer with the control on
the subwoofer. It is also possible to adjust the volume level
using this unit’s remote control (see page 69).
• Some signals may not be output from the SUBWOOFER jack
depending on the Speaker Set (see page 67) and LFE Level (see
page 63) settings.
■
Connecting external preamplifiers
If you want to input signals from another preamplifier,
connect the external preamplifier to the FRONT IN/
CENTER IN jacks.
1
FRONT IN jacks
Line input to this unit’s front channel amplifiers. When
connecting to these jacks, signals input to this unit’s
preamplifier will not be output from the unit’s front
amplifier.
2
CENTER IN jack
Line input to this unit’s center channel amplifier. When
connecting to this jack, signals input to this unit’s
preamplifier will not be output from the unit’s center
amplifier.
■
Connecting i.LINK components
If you have a component with an i.LINK connector, you
can enjoy digital audio from CD, DVD, Super Audio CD
or DVD-A discs.
Notes
Notes
OUT
FRONT
CENTER
SURROUND
BACK
PRESENCE
SUBWOOFER
OUT
(SINGLE)
L
R
SURROUND
(REAR)
(FRONT)
POWER AMP IN
1
2
3
4
5
6
FRONT
CENTER
POWER AMP IN
POWER AMP IN
1
2
S400
(AUDIO)
i.LINK component
00EN.00_DSPZ9_GB.book Page 26 Thursday, November 13, 2003 10:55 AM