Yamaha RX-V800RDS User Manual

Page 72

TROUBLESHOOTING

Problem

Cause

Remedy

Refer to
page

The volume level
cannot be increased,
or the sound is
distorted.

The component connected to the REC OUT
jacks of this unit is turned off.

Turn on the power to the component.

The sound effect
cannot be recorded.

It is not possible to record the sound effect by
a recording component.

“CHECK SP WIRES”
appears on the front
panel display.

The sound is degraded
when listening with
headphones
connected to a tape
deck or CD player that
is connected to this
unit.

There is noise
interference from
digital or high-
frequency equipment,
or the unit.

The unit is too close to the digital or high-
frequency equipment.

Move the unit further away from such
equipment.

This unit does not
operate properly.

The internal microcomputer has been frozen
by an external electric shock (such as
lightning or excessive static electricity) or by
a power supply with low voltage.

Disconnect the AC power cord from the
outlet and then plug it in again after about
30 seconds.

A source cannot be
recorded by a digital
recording component
connected to the
DIGITAL OUTPUT jack
of this unit.

A source component is only connected to the
analog input jacks of this unit.

Connect the source component to the digital
input jacks of this unit.

The sound field
parameters and some
other settings on this
unit cannot be
changed.

“15 MEMORY GUARD” on the SET MENU
is set to ON.

Select OFF.

Speaker cables are short circuited.

Make sure all speaker cables are connected
correctly.

This unit is in the standby mode.

Turn on the power of the unit.

12 – 15

—

16, 17

—