Yamaha RX-V800RDS User Manual

Page 29

English

INTR

ODUCTION

PREP

ARA

TION

ASIC

OPERA

TION

ANCED

OPERA

TION

ADDITIONAL

INFORMA

TION

APPENDIX

BASIC PLAYBACK

■ Notes on playing a source

encoded with a DTS signal

•

If the digital output data of the player has been
processed in any way, you may not be able to
perform DTS decoding even if you make a digital
connection between this unit and the player.

•

If you play a source encoded with a DTS signal and
set the input mode to ANALOG, this unit reproduces
the noise of an unprocessed DTS signal. When you
want to play a DTS source, be sure to connect the
source to a digital input jack and set the input mode
to AUTO or DTS.

•

If you switch the input mode to ANALOG while
playing a source encoded with a DTS signal, this unit
reproduces no sound.

•

If you play a source encoded with a DTS signal and
set the input mode to AUTO, there will be a moment
of noise while the unit recognizes the DTS signal and
turns on the DTS decoder. This is not a malfunction.
You can avoid this by setting the input mode to DTS
beforehand.

•

If you continue to play a source encoded with a DTS
signal with the input mode setting left to AUTO, this
unit automatically switches to the “DTS-decoding”
mode to prevent noise from being generated during
subsequent operation. (The “t” indicator lights
up on the front panel display.) The “t” indicator
will flash immediately after playback of a source
encoded with a DTS signal has finished. Only a
source encoded with a DTS signal can be played
back while this indicator is flashing. If you want to
play a normal PCM source soon, set the input mode
back to AUTO.

•

The “t” indicator will flash when the input mode
is set to AUTO and a search or skip operation is
performed while playing back a source encoded with
a DTS signal. If this status continues for 30 or more
seconds, the unit will automatically switch from the
“DTS-decoding” mode to PCM digital signal input
mode and the “t” indicator will go out.

■ Notes on playing an LD source

• For LD software that does not contain a digital

soundtrack, connect the LD player to the analog jacks
and set the input mode to AUTO or ANALOG.

• If the LD player is transmitting a signal by a non-

standard method, this unit cannot detect the Dolby
Digital or DTS signal. In this case, the decoder
automatically switches to PCM or analog.

• Some A/V components such as LD players output

different audio signals through their analog and digital
jacks. Change the input mode as necessary.

• While you are operating the LD player and playing a

disc encoded with a Dolby Digital signal, if you
switch from the pause or chapter forwarding function
to normal playback, you may hear the PCM or analog
sound an instant before the Dolby Digital signal is
played.