Yamaha RX-V800RDS - Manual (Page 57)

55
English
INTR
ODUCTION
PREP
ARA
TION
B
ASIC
OPERAIONT
AD
V
ANCED
OPERA
TION
ADDITIONAL
INFORMA
TION
APPENDIX
REMOTE CONTROL FEATURES
Programming a New Remote
Control Function (Learn Feature)
If you want to program functions not included in the basic
operations covered by the manufacturer code, or a
manufacturer code is not available, the following
procedure needs to be performed. You can program
functions to all buttons except DSP and INPUT in all
positions of the selector dial other than AMP/TUN and
DSP/TUN, so the buttons are programmable
independently for each position of the selector dial.
y
• You can program about 60 buttons.
Note
• This remote control transmits infrared rays. If the other remote
control also uses infrared rays, this remote control can learn
most of the other remote control’s functions. However, you
may not be able to program some special signals or extremely
long transmissions. (Refer to the operation instructions for the
other remote control.)
1 Set the selector dial to the
desired position for the
component to be
programmed.
2 Place this remote control and the other
remote control about 10 to 40 mm (3/8” to
1-1/2”) apart on a flat surface so that their
infrared transmitters are aimed at each other.
10 to 40 mm (3/8” to 1-1/2”)
3 Press and hold e and p at the same time
for about 4 seconds.
The indicator flashes twice.
Note
• If you do not press any button within 30 seconds during steps 4
and 5, the indicator flashes twice and the learning process is
canceled. If this happens, start over from step 3.
4 Press the button for which you want to
program the new function.
The indicator lights up.
Lights up
5 Press and hold the button on the other
remote control that has the function you
want to program into this remote control
until the indicator goes off.
Goes off
Notes
• If this remote control cannot receive the signals from other
remote control, the indicator flashes rapidly.
• When the memory is full, the indicator flashes twice and this
remote control cannot acquire any more functions. Clear
unnecessary programmed functions to allow this remote control
to acquire new functions.
• If you do not press any button within 30 seconds after step 5,
the indicator flashes twice. This indicates that the learning
process is complete and the remote control has exited from the
learning mode.
6 Repeat steps 4 and 5 to program additional
functions.
7 Press DSP or INPUT, or turn the selector dial
to exit from the learning mode.
The indicator flashes twice.
Notes
• Even if the batteries in the other remote control have enough
power to transmit signals for operation, they may not have
enough power to transmit signals to this remote control.
• When the remote controls are either too close together or too
far apart, you may not be able to program this remote control.
• Direct sunlight interferes with infrared rays.
Memory back-up
If the remote control is without batteries for more than
2 minutes, or if exhausted batteries remain in the
remote control, the contents of the memory may be
cleared. When the memory is cleared, insert new
batteries, set up the manufacturer code and program
any acquired functions that may have been cleared.