Auditioning the channels [channellisten, Deleting data from each channel [channelclear, Ch1 - ch16 – Yamaha CLP-990M EN User Manual
Page 75: Ch1 - ch16, all (all channels)
CLP-990
75
Detailed settings for recording and playback [SONG SETTING]
This parameter enables you to specify whether a song
that starts from the middle of a bar, or a song with a
silence prior to the first note, should be played from
the first note or from the top of the bar (rest or blank).
See the procedure on page 72.
Setting range:
[On] Playing from the first note
[Off] Playing from the top of the bar (including a rest
or blank)
You can select a single channel to listen to its contents.
Playback starts from the first note.
See the procedure on page 72.
Setting range:
Ch1 - Ch16
Usually, channels that do not contain any data are not dis-
played. However, for some songs, all channels (including the
channels that contain no data) may be displayed.
You can delete data from each of 16 channels.
See the procedure on page 72.
Setting range:
Ch1 - Ch16, ALL (all channels)
• Channels that do not contain any data are not displayed.
However, for some songs, all channels (including the
channels that contain no data) may be displayed.
• Save the edited song data to memory or disk.
(See page 50.)
You can specify a range (in steps of beats) in a song to
play back repeatedly.
• Playback repeats after it reaches just prior to the beat
specified as the end point.
• If you start playing back a song with “Repeat On”
selected, the count down starts, followed by the
repeated playback of the specified part until you
press the [STOP] button.
• If you select “Repeat Off,” normal playback starts.
See the procedure on page 72.
When you select another song, the specified range is auto-
matically cancelled and the Repeat function is turned off.
Specifying whether playback
starts immediately along with the
first voicing [QuickPlay]
Auditioning the channels [Chan-
nelListen]
A
B
C
D
NO
YES
A
B
C
D
NO
YES
Use these buttons to select the desired channel
for playback.
Playback continues as long
as you press and hold down this button.
TIP
Deleting data from each channel
[ChannelClear]
Specifying the range and playing
back repeatedly [FromToRepeat]
A
B
C
D
NO
YES
Press this button to delete data.
Use these buttons to select the desired channel
for deletion.
TIP
A
B
C
D
NO
YES
Use these buttons
to specify the end point
of the repeated range.
Use these buttons to select “Repeat On.”
Use these buttons
to specify the start point
of the repeated range.
NOTE