Maintenance and servicing, Fitting a new door seal – Yeoman CL MILNER BRICK YMMB User Manual
Page 26
26
PR8739
Glass rope
seal
B
Black face
—
Place the glass into position in the door.
—
Place the glass clamp into position.
—
Re-fix with the clean fixing screws.
—
Tighten the screws evenly until the clamp holds the
glass.
6.2 Fitting the door is the reverse of the process detailed in
Installation Section 2, Page 20.
The door may require some adjustment once refitted, see
Maintenance & Servicing Section 8, Page 27.
Do not over tighten the clamp as this could break the
glass.
6.3 Fit only Yeoman ceramic glass, which is suitable to use in
high temperature applications.
6.4 Using the appliance with damaged door glass could allow
dangerous fumes to enter the room, or the appliance to
over-fire and cause damage.
MAINTENANCE and SERVICING
7. FITTING A NEW DOOR SEAL
7.1 To maintain the safe use of your appliance you may need to
replace a damaged or worn door sealing rope. To do this:
—
Open the door.
—
Lift it free of the hinge blocks - see Section 6.1.
—
Lie the door face down on a soft flat surface, to protect
the paintwork and glass.
PR8758
Joint
Mid door
rope seal E
Door rope seal D
Door rope seal C
Seal
Length (mm)
Door rope seal C
1070
Door rope seal D
170
—
Remove the old rope.
—
Scrape old glue from the locating groove.
—
Clean the locating groove with a clean dry cloth
removing all dust and debris.
—
Apply Stovax Thermic Seal glue (Stovax Part No. 5037)
into the rope locating groove.
—
Press the new rope into the locating groove,
placing the joint in the middle of the lower edge of the
door.
—
Refit the door.
—
Close to apply pressure on the new rope.
7.2 Fitting the door is the reverse of the process detailed in
Installation Section 2, Page 20.
The door may require some adjustment once refitted, see
Maintenance & Servicing Section 8, Page 27.
7.3 Leave the appliance closed for at least 12 hours before
lighting the stove.
7.4 Use at a low temperature for approximately one day.
Using the stove with a damaged door seal could allow
dangerous fumes to enter the room, or the appliance to
over-fire and cause damage.