Yeoman CL MILNER BRICK YMMB - Manual (Page 19)

19
LEGAL REQUIREMENTS
Before installation and/or use of this appliance please read
these instructions carefully to ensure that all requirements are
fully understood.
The appliance must be fitted by a registered installer * , or
approved by your local building control officer.
It is very important to understand the requirements of the national
Building Regulations † and standards‡, along with any local
regulations and working practices that may apply. Should any
conflict occur between these instructions and these regulations
then the regulations must apply.
Your local Building Control Office can advise regarding the
requirements of the regulations.
The appliance must be fitted by a registered installer* or approved
by your local building control officer.
Works must be carried out with care to meet the requirements
of Health and Safety‡ and comply with the Health and Safety
rules**, and any new regulations introduced during the lifetime of
these instructions. Particular attention should be drawn to:
—
Handling : The appliance is heavy. Adequate facilities
must be available for loading, unloading and on site
handling.
—
Fire Cement : Some fire cement is caustic and must not
come into contact with the skin. Protective gloves
must be worn. Wash hands thoroughly with plenty of
water after contact with skin.
—
Asbestos : This appliance contains no asbestos. If there
is the possibility of disturbing any asbestos in the course
of installation seek specialist guidance and use
appropriate equipment.
—
Metal Parts : Take care when installing or servicing the
stove to avoid personal injury.
A faulty installation can cause danger to the inhabitants and
structure of the building.
For users of this appliance:
Your building insurance company may require you to inform them
that a new heating appliance has been installed on your property.
Check that your cover is still valid after installing the appliance.
INSTALLATION INSTRUCTIONS
1. INSTALLING THE APPLIANCE
Each installation is unique to the property so it is not possible
to give details to suit every setting. The installation must comply
with Building Regulations and be made using "best practice"
construction methods.
Many fireplace openings have a supporting lintel. Do not remove
without supporting the remaining structure of the building. Do not
support the structure with the appliance or the flue system .
Take care when installing the appliance. Careless handling and
use of tools can damage the finish and/or area .
1.1 Remove the baffles and grate to make installation access
easier and prevent damage (see following removal
instructions).
1.2 Check the operation of the air slider under the lip plate
Ensure it operates smoothly (see Secondary Air Controls,
page 5).
1.3 Affix ø16 rope (supplied) to the rear of the stove, as shown
in Diagram 1, using thermic seal. The stove must be sealed
against the face of the chimney breast.
PR9145
1
Clamps
ø16 Rope
1.4 Protect the hearth and position the stove. Rotate the
clamps to clear the opening and slide stove into position
(see Diagram 2).
PR9038
ø16mm rope
Rotate clamps
Slide stove
into position
2
† England and Wales – Document J / Scotland - Part F/
Document J (Republic of Ireland only)
‡ Latest editions of BS 8303, BS EN 15287, BS 7566
*Registered on the Competent Persons Scheme (GB only)
see page 26 / INFO (Republic of Ireland).
**Health and Safety at Work Act 1974