Yeoman CL MILNER BRICK YMMB - Manual (Page 22)

22
INSTALLATION INSTRUCTIONS
6. REMOVAL OF CLEANBURN CHAMBER
10
PR9045
Cap head screws
6.1 Remove the 4 M6 x 25 cap head screws using 5mm
hexagonal key.
6.2 Lift chamber, rotate forward and remove from stove.
6.3 Check rope seal is in good condition (see Diagram 11). If
necessary, replace using Yeoman 10 x 2 insulation tape
(Yeoman Part No. 4953).
11
PR9046
7. REMOVAL OF CAST IRON FIREBRICKS
7.1 Allow the appliance to cool fully before removing firebricks.
7.2 Replace damaged firebricks as soon as possible.
7.3 To remove bricks:
—
Remove grate (see Section 5).
—
Remove clean burn chamber (see Section 6).
—
Remove brick by rotating as shown in Diagram 12.
PR9047
12
8. CO ALARMS
All open flued appliances can be affected by temporary
atmospheric conditions which may allow fumes to enter
the house. Building regulations require that whenever
a new or replacement fixed solid fuel or wood/biomass
appliance is installed in a dwelling a carbon monoxide
alarm must be fitted in the same room as the appliance.
Further guidance on the installation of the carbon
monoxide alarm is available in the latest edition of
BS EN 50292 and from the alarm manufacturer's
instructions.
Provision of an alarm must not be considered a
substitute for either installing the appliance correctly
or ensuring regular servicing and maintenance of the
appliance and chimney system.