Yamaha DVD-S659BL - Manual (Page 30)

26 En
Setup Menu
Setting the HDMI audio
When you connect this unit to an HDMI
compatible component via the HDMI jack,
select to turn on or off the HDMI audio
output.
1 In ‘AUDIO SETUP PAGE’, press 34 to
highlight [HDMI AUDIO], then press 2.
ON
Select this to turn on the HDMI audio
output.
OFF
Select this to turn off the HDMI audio
output.
Notes:
– If you are not using the HDMI audio
output, you should set this to [OFF].
– If the monitor/receiver connected to this
unit using HDMI does not support HDMI
audio signal input, set this to [OFF].
– This unit can output following audio signals
using HDMI: 32/44.1/48 kHz, 2ch linear
PCM signals and bitstream signals (Dolby
Digital, DTS and MPEG).
– When audio signals are being output by
HDMI-compatible components, digital
output signals are muted.
– When [DIGITAL OUTPUT] is set to [OFF]
on this unit, HDMI audio is muted even if
[HDMI AUDIO] is set to [ON] and an
HDMI connection is established between
the monitor and receiver.
– When [DIGITAL OUTPUT] is set to [ALL]
on this unit, PCM signals are still output if
the monitor and receiver only support the
PCM format. However, the audio output is
muted when audio format plays back the
DTS source.
CD upsampling
This feature allows you to convert your
music CD to a higher sampling rate using
sophisticated digital signal processing for
better sound quality. If you activate the
upsampling function, this unit automatically
switches to the stereo mode.
1 In “AUDIO SETUP PAGE”, press 3 / 4 to
highlight [CD UPSAMPLING], and then
press 2.
OFF
Select this to disable CD-upsampling.
88.2kHz (X2)
Select this to convert the sampling rate of
CDs to twice that of the original.
176.4kHz (X4)
Select this to convert the sampling rate of
CDs to four times that of the original.
2 Press 3 / 4 to select a setting, and then
press ENTER/OK to confirm your
selection.
Note:
– This setting is only valid for the signals
output at the analog jacks.
Night mode
In the night mode, high volume output is
softened and low volume output is brought
upward to an audible level. It is useful when
you watch your favorite action movie
without disturbing others at night.
1 In “AUDIO SETUP PAGE”, press 3 / 4
to highlight [NIGHT MODE], and then
press 2.
TIPS: To return to the previous menu, press 1.
To exit from the menu, press SETUP.
00EN_DVD-S659_U.book Page 26 Monday, June 12, 2006 4:19 PM