Yamaha DRCX - Manual (Page 41)

35
CHAPTER2 Ethernet Unit
2-14 Specifications
2-14-1 Ethernet unit specifications
! CAUTION
We use an FL HUB (made by Phoenix Contact) to check operation. Using this
HUB is recommended if constructing your own system.
HUBs generally available on the market are not designed for use in locations such
as factories, so some HUBs are vulnerable to external noise. Please acknowledge
beforehand that operation cannot be guaranteed if other types of HUBs are used.
Always be sure to use a HUB with high noise resistance when connecting to the
controller.
Ethernet unit
Network specs
Maximum cable length
Applicable controllers
Baud rate
Connector
Cable
Monitor LED *1)
Number of simultaneous logins 1
IP address setting From TPB
Spec item
Model
*1) The upper lid of the controller must be removed to monitor the LED.
NOTE: The product external appearance and specifications are subject to change without
prior notice for purposes of improvements or other factors.
Conforms to Ethernet (IEEE802.3)
SRCP/SRCD/ERCX/SRCX/DRCX series controllers
10Mbps (10BASE-T)
RJ-45 connector (octal modular connector) 1 port
UTP (unshielded twisted-pair) cable for category 3 or higher,
or STP (shielded twisted-pair) cable
Half Duplex
100 meters (between HUB and controller)
Communication mode
Application layer : TELNET
Transport layer : TCP
Network layer : IP, ICMP, ARP Network protocol
Run, Collision, Link, Transmit, Receive
Data link layer : CSMA/CD
Physical layer : 10BASE-T