Yamaha RX-V2700 - Manual (Page 140)

138
En
TROUBLESHOOTING
■ Auto Setup
Before Auto Setup
During Auto Setup
Error message Cause Remedy
See
page
Connect MIC! Optimizer microphone is not connected. Connect the supplied optimizer microphone
to the OPTIMIZER MIC jack on the front
panel.
35
Unplug Phones! Headphones are connected. Unplug the headphones. —
No Setup Menu! All setup menu are set to “Skip”. Set the desired menu item to “Check”. 36
Memory Guard! “Memory Guard” is set to “On”. Set “Memory Guard” to “Off”. 105
Error message Cause Remedy
See
page
E01:No Front SP Front L/R channel signals are not detected. Check the front L/R speaker connections. 16
E02:No Sur. SP A surround channel signal is not detected. Check the surround speaker connections. 16
E03:No PRNS SP A presence channel signal is not detected. Check the presence speaker connections. 16
E04:SBR->SBL Only right surround back channel signal is
detected. Connect the surround back speaker to the
LEFT SURROUND BACK SPEAKERS
terminal if you only have one surround
back speaker.
16
E05:Noisy Background noise is too loud. Try running “Auto Setup” in a quiet
environment.
—
Turn off noisy electric equipment like air
conditioners or move them away from the
optimizer microphone.
—
E06:Check Sur. Surround back speakers are connected,
though surround L/R speakers are not. Connect surround speakers when you use
surround back speakers.
16
E07:No MIC The optimizer microphone was unplugged
during the “Auto Setup” procedure. Connect the supplied optimizer microphone
to the OPTIMIZER MIC jack on the front
panel.
35
E08:No Signal The optimizer microphone does not detect
test tones. Check the microphone setting. 35
Check the speaker connections and
placement.
16
E09:User Cancel The “Auto Setup” procedure was cancelled
due to user activity. Run “Auto Setup” again.
35
E10:Internal Err. An internal error occurred. Run “Auto Setup” again. 35