Zenith J3W41321A - Manual (Page 14)

14
Starting setup
4
2
3
Press
or
to select
“START”, then press ENTER.
If you select “CANCEL” and
press ENTER, the STARTING
SETUP stops and changes to
the TV screen.
1
Press POWER. The starting
setup function begins and
the Language setup menu
appears on the screen.
Press
or to select
your desired language, then
press ENTER.
IMPORTANT: Make sure that the antenna or cable TV system
connection is made!
Press
or
to select “TV”
or “CABLE”, then press
ENTER.
The STARTING SETUP menu appears
the first time you turn on the TV, and
assists you to select the menu
language, specify the TV/CABLE
setting, and program your channels
automatically.
• When you make a menu selection, your changes occur immediately.
You do not have to press EXIT to see your changes.
• When you are finished programming the menus, press EXIT.
NOTE:
If you press EXIT in the process of “AUTO SETUP”, the STARTING
SETUP stops and changes to the normal screen.
: S E L E C T E N T E R : S E T
L A N G U A G E / L A N G U E / I D I O M A
E N G L I S H
F R A N Ç A I S
E S PA Ñ O L
: S E L E C T E N T E R : S E T
C H A N N E L P L A N
T V
C A B L E
: S E L E C T E N T E R : S E T
A U T O S E T U P
S TA R T
C A N C E L
Now the “AUTO SETUP” starts. After the starting setup is com-
pleted, the TV channel appears on the screen.
• Depending on the reception condition, it may take approximately
10 minutes to complete memorizing digital cable channels.
Please be patient.
PICTURE
SIZE
-/
J3W41321A_En_P14-17 24/03/2006, 2:22 PM 14