Yamaha HTR-5490 User Manual

Page 77

English

INTR

ODUCTION

PREP

ARA

TION

ASIC

OPERAIONT

ANCED

OPERA

TION

ADDITIONAL

INFORMA

TION

APPENDIX

TROUBLESHOOTING

Problem

The volume level is low
while playing a record.

The volume level
cannot be increased, or
the sound is distorted.

The sound effect
cannot be recorded.

A source cannot be
recorded by a digital
recording component
connected to the
DIGITAL OUTPUT jack
of this unit.

The sound field
parameters and some
other settings on this
unit cannot be
changed.

This unit does not
operate properly.

“CHECK SP WIRES”
appears on the front
panel display.

The sound is degraded
when listening with
headphones connected
to a tape deck or CD
player that is connected
to this unit.

There is noise
interference from digital
or high-frequency
equipment, or this unit.

This unit suddenly
turns into the standby
mode.

Cause

The record is being played on a turntable
with an MC cartridge.

The component connected to the REC
OUT jacks of this unit is turned off.

It is not possible to record the sound
effect by a recording component.

A source component is only connected to
the analog input jacks of this unit.

“14 MEMORY GUARD” on the SET
MENU is set to ON.

The internal microcomputer has been
frozen by an external electric shock (such
as lightning or excessive static electricity)
or by a power supply with low voltage.

Speaker cables are short circuited.

This unit is in the standby mode.

This unit is too close to the digital or
high-frequency equipment.

The internal temperature becomes too
high and the overheat protection circuitry
has been activated.

Remedy

The turntable should be connected to this unit
through an MC-head amplifier.

Turn on the power to the component.

Connect the source component to the digital
input jacks of this unit.

Select OFF.

Disconnect the AC power cord from the outlet
and then plug it in again after about 30 seconds.

Make sure all speaker cables are connected
correctly.

Turn on the power of this unit.

Move this unit further away from such
equipment.

Wait until this unit cools down and then turn it
back on.

Refer
to page

16, 17

11 – 17

—

12, 13

—

0111HTR5490_71-78_EN(UA)

01.7.6, 6:12 PM