Impedance selector switch – Yamaha HTR-5490 User Manual
Page 17
13
English
INTR
ODUCTION
PREP
ARA
TION
B
ASIC OPERA-
TION
AD
V
ANCED
OPERA
TION
ADDITIONAL
INFORMA
TION
APPENDIX
SPEAKER SETUP
AC OUTLETS
SET BEFORE POWER ON
MAIN A OR B:
A+B:
CENTER
4
ΩMIN. /SPEAKER
8
ΩMIN. /SPEAKER
6
ΩMIN. /SPEAKER
6
ΩMIN. /SPEAKER
6
ΩMIN. /SPEAKER
8
ΩMIN. /SPEAKER
16
ΩMIN. /SPEAKER
8
ΩMIN. /SPEAKER
8
ΩMIN. /SPEAKER
8
ΩMIN. /SPEAKER
REAR CENTER :
:
:
MAIN A OR B:
A+B:
CENTER
REAR
REAR CENTER :
:
:
IMPEDANCE SELECTOR
REAR
8
ΩMIN. /SPEAKER
16
ΩMIN. /SPEAKER
8
ΩMIN. /SPEAKER
8
ΩMIN. /SPEAKER
8
ΩMIN. /SPEAKER
MAIN A OR B:
A+B:
CENTER
REAR
REAR CENTER :
:
:
IMPEDANCE SELECTOR
SET BEFORE POWER ON
MAIN A OR B:
A+B:
CENTER
4
ΩMIN. /SPEAKER
8
ΩMIN. /SPEAKER
6
ΩMIN. /SPEAKER
6
ΩMIN. /SPEAKER
6
ΩMIN. /SPEAKER
REAR
REAR CENTER :
:
:
Switch
position
Left
Right
Speaker
Main
Center
Rear
Center
Rear
Main
Center
Rear
Center
Rear
Impedance level
If you use one set of main speakers, the impedance of
each speaker must be 4
Ω or higher.
If you use two sets of main speakers, the impedance of
each speaker must be 8
Ω or higher.
The impedance must be 6
Ω or higher.
The impedance must be 6
Ω or higher.
The impedance of each speaker must be 6
Ω or higher.
If you use one set of main speakers, the impedance of
each speaker must be 8
Ω or higher.
If you use two sets of main speakers, the impedance of
each speaker must be 16
Ω or higher.
[Canada model only]
The impedance of each speaker must be 8
Ω or higher.
The impedance must be 8
Ω or higher.
The impedance must be 8
Ω or higher.
The impedance of each speaker must be 8
Ω or higher.
IMPEDANCE
SELECTOR
switch
(U.S.A. model)
■ IMPEDANCE SELECTOR switch
WARNING
Do not change the IMPEDANCE SELECTOR switch setting while the power of this unit is on, otherwise this unit
may be damaged.
If this unit fails to turn on when STANDBY/ON (or SYSTEM POWER) is pressed, the IMPEDANCE SELECTOR
switch may not be fully slid to either position. If so, slide the switch to either position fully when this unit is in the
standby mode.
Select the left and right position according to the impedance of the speakers in your system. Be sure to move this switch
only when this unit is in the standby mode.
0103HTR5490_10-18_EN(UA)
01.7.6, 6:11 PM
13