ZyXEL Communications P841C - Manual (Page 31)

P841C Central-Side VDSL Modem
Ethernet-Related Commands 5-3
5.1.2 Enet Clear Command
enet clear
Type this command to clear P841C and the subscriber’s VDSL modem’s Ethernet statistics (if link is up).
5.1.3 Enet Speed (lt|nt) (speed) Command
enet speed (lt|nt) (speed)
Type this command to set the Ethernet port speed of the P841C (with “lt”) or P841 (with “nt”). P841C speed is
displayed if you just type “enet speed”.
Figure 5-2 Ethernet Speed
Speed index number Speed/Flow Control
0 Auto Negotiation
1 10 Mbits/s, Half Duplex
2 10 Mbits/s, Full Duplex
3 100Mbits/s, Half Duplex
4 100Mbits/s, Full Duplex
5.1.4 Enet full duplex Fctrl (lt|nt) [on|off] Command
enet full duplex fctrl (lt|nt) [on|off]
Type this command to set the Ethernet port flow control or show the Ethernet port flow control status (without
“on” or “off”). By default, flow control is on for full duplex Ethernet connections and off for half duplex Ethernet
connections.
Figure 5-3 Ethernet Flow Control
5.1.5 Enet Monitor [on|off] Command
enet monitor [on|off]
P841C>enet fctrl
enet full duplex flow control(LT): on
P841C>enet speed
enet speed(LT): Auto