Bosch TCA5608 - Manual (Page 19)

17
TCA56 06/2009
en
● Fill the cup approximately 1/3 full of milk.
● Press the h button. It will start to flash.
i The appliance will heat up for approx. 20
seconds.
● Immerse the nozzle 9 deep into the milk,
but do not let it touch the bottom of the
cup.
● When the h button lights up and 8
appears on the display, turn the dial 8 to
g / h .

! Risk of scalding
When the dial 8 is set to g / h , the nozzle
9 may sputter. Escaping steam is very hot
and may cause liquids to sputter. Do not
touch the nozzle 9 or aim it at anyone.
● Rotate the cup slowly until the milk is fully
foamed.
● End the process by turning the dial 8
back to “ O”.
Note: When the nozzle 9 has cooled
down, clean it immediately. Dried residue is
difficult to remove.
Tip: If possible, use cold low­fat (1.5% fat)
milk.
Steam for warming milk

! Risk of burns
The nozzle gets very hot. Do not touch the
metal parts!
The appliance must be ready for use.
● Push the sleeve on the nozzle 9 all the
way up.
● Press the h button. It will start to flash.
i The appliance will now heat up for
approx. 20 seconds.
● Immerse the nozzle 9 deep into the liquid
you want to heat.
● When the h button lights up and 8
appears on the display, turn dial 8 to g /
h .

! Risk of scalding Risk of scalding
When the dial 8 is set to g / h , the nozzle
9 may sputter a little. Escaping steam is
very hot and may cause liquid to sputter.
Do not touch the nozzle 9 or aim it at
anyone.
● End the process by turning the dial 8
back to “ O”.
Note: When the nozzle 9 has cooled down,
clean immediately. Dried residue is difficult
to remove.
Maintenance and daily
cleaning

! Risk of electric shock
Unplug the appliance before cleaning it.
Never immerse the appliance in water. Do
not use a steam cleaner.
● Wipe the outside of the appliance with a
damp cloth. Do not use scouring agents.
● Always remove any limescale,
coffee, milk or descaling fluid residue
immediately. Such residue can cause
corrosion.
● Wash all removable parts by hand only.
● Rinse out the water tank 1 with water
only.
● Remove, empty and clean the trays for
coffee grounds 0 and residual water 1.
● Wipe out the inside of the appliance (tray
holders).
Note: If the appliance is cold when switched
on, or if it is switched to “ eco” mode after
dispensing coffee, it rinses automatically; in
other words the system cleans itself.
Nozzle 9 for hot water/steam
● Unscrew the nozzle 9 from the steam
pipe.
● Dismantle all parts (Fig. E).
● Clean with a caustic cleaning solution and
a soft brush. Clean the tip of the nozzle
9c with a blunt needle.
● Thoroughly rinse and dry all parts.