Bosch TCA5608 - Manual (Page 18)

16
Robert Bosch Hausgeräte GmbH
en
Tip: Pre­warm cups, especially small, thick
espresso cups, by placing on the cup shelf
15 or rinsing with hot water.
Using coffee beans
The appliance must be ready for use.
● Set the desired per­cup quantity using
dial .
● Select the desired coffee strength using
button 5 .
● Place the prewarmed cup(s) under the
coffee outlet 10.
● Press the coffee dispensing button 4
once for 1 cup or twice within three
seconds for 2 cups. The coffee is brewed
and dispensed into the cup(s).
Warning
If you select two cups, the grinding and
brewing process is performed twice.
● Coffee dispensing stops automatically
when the selected quantity has been
dispensed.
i The brewing process can be terminated
by pressing the coffee dispensing button
4 again. When coffee is brewed for
2 cups, it is dispensed via two outlet
nozzles (place the cups side by side).
Using ground espresso/
coffee powder
The appliance must be ready for use.
● Set the desired per­cup quantity using the
dial .
● Place the prewarmed cup(s) under the
coffee outlet 10.
● Open the cover of the ground coffee duct 14.
● Add one to two level scoops of ground
coffee (grind: medium­fine) to the ground
coffee duct 14.
Warning
Do not add whole beans or instant coffee!
Use a maximum of two level scoops of
coffee.
● Close the cover of the ground coffee duct 14.
● Press the coffee dispensing button 4 .
i Repeat the process if a second cup is
desired.
Note: If coffee is not brewed within 90
seconds, the brewing chamber is emptied
automatically in order to prevent overfilling.
The appliance is rinsed.
Preparing hot water
The appliance must be ready for use. This
function allows water to be heated for a cup
of tea, for example.

! Risk of burns
The nozzle gets very hot. Do not touch the
metal parts!
● Place an appropriate cup under the
nozzle 9.
● Push the sleeve on the nozzle 9 all the
way down.
● Turn the dial 8 to g / h .

! Risk of scalding
When the dial 8 is set to g / h , the nozzle
may sputter a little. Do not touch the nozzle
9 or aim it at anyone.
● End the process by turning the dial 8
back to “ O”.
Important: It is not possible to dispense
hot water when the appliance is in “ eco”
mode. First press the eco button and then
dispense hot water.
Steam for foaming milk
The appliance must be ready for use. You
can foam the milk first and add the coffee
on top, or foam the milk separately and
pour it into the coffee.

! Risk of burns
The nozzle gets very hot. Do not touch the
metal parts!
● Push the sleeve on the nozzle 9 all the
way down.