beautypg.com

Preparation – Bosch TCA5608 User Manual

Page 17

background image

15

TCA56 06/2009

en

● Switch the appliance to “

eco” mode.

● Hold down the steam button

h

for at

least 5 seconds. The number of service

buttons

4

,

5

,

eco,

h

that light up

indicate the selected water hardness.

● Press the steam button

h

repeatedly

until the correct number of buttons is lit.

● Press

eco button

once. The selected

number of service buttons should light

up briefly; this indicates that the desired

water hardness setting has been saved

successfully.

If a water filter (special accessory) is used,

the water hardness should be set to 1.

Note: If no button is pressed within 90

seconds, the appliance switches to stand­

by mode without saving the new settings.

In this case, the previous water hardness

setting is retained.

The first time a filter is used or after

changing the filter, the appliance needs to

be cleaned.

● Fill the water tank up to the 0.5l mark.

● Place a suitable container (approx. 0.5

litres) under the nozzle

9.

● Turn the dial

8 to

g

/

h

.

● If no water comes out of nozzle

9, turn

the dial back to “

O”.

● Fill the water tank and water pipes (see

section “Switching on the appliance”).

Setting the time for switchover to “eco”

mode

The appliance can be programmed so that

it automatically switches to “

eco” mode

after a certain time (from 10 minutes to 4

hours).

● Switch the appliance to “

eco” mode.

● Hold down the

5

button for at least 5

seconds.

If

4

lights up,

switchover after 10 minutes

If

4

,

5

lights up,

switchover after 30 minutes

If

4

,

5

,

eco lights up,

switchover after 2 hours

If

4

,

5

,

eco,

h

lights up,

switchover after 4 hours

● Press the

5

button to set the required

time.

● Press the

eco button to save the setting.

Note: The factory setting is 10 minutes.

Adjusting the grinding unit

Sliding switch

16 adjusts the degree of

grinding, from coarse to fine.

Warning

Adjust the grinding unit only while it is

running! Otherwise the appliance may be

damaged.

● Press the coffee dispensing button

4

.

● While the grinding unit is running, move

the sliding switch

16 to the desired

position: the smaller the dots, the finer the

grind.

i

The new setting will not become apparent

until the second or third cup is brewed.

Tip: For dark roast coffee beans, choose a

coarser grind; for light roast beans, select a

finer grind.

Float

The float

in the water tray 1 shows

when the tray needs emptying.

● If the float

is clearly visible, empty the

water tray

1.

Preparation

This fully automatic espresso/coffee

machine grinds beans freshly for each

brew. If possible, use only beans for fully

automatic coffee and espresso machines.

Deep­freeze or store in a cool place in

sealed, airtight containers. Coffee beans

can be ground while frozen.

Important: Fill the water tank with fresh

water every day. The tank must always

contain sufficient water for operating the

appliance. Do not allow it to become empty.

This manual is related to the following products: