Yamaha htr-5890 - Manual (Page 83)

79
ZONE 2/ZONE 3
A
D
V
ANCED
OPERA
T
ION
4
You can control the unit from Zone 2 or Zone
3 by using the input selector, STANDBY,
SYSTEM POWER, MUTE and VOLUME +/–
buttons.
* VOLUME +/– can be used only when OUTPUT VOL is
set to VAR. in SET MENU (see page 64).
5
Press SELECT k / n to exit from the Zone 2/
Zone 3 mode.
• The source in Zone 2 and the source available for recording are
always the same.
• “ZONE2” or “ZONE3” will appear in the display window only
when k is pressed, and “SYSTM” only when n is pressed.
■ Turning this unit to either on or standby
SYSTEM POWER and STANDBY work differently
depending on the selected mode that appears on the
display window.
• When normal, Zone 2 or Zone 3 mode is selected, you
can turn the main unit, Zone 2 or Zone 3 to on/standby
individually.
• When System mode is selected, or when “AMP1” is
selected as the amplifier library (L:AMP) code, you
can turn the main unit, Zone 2 and Zone 3 to on/
standby simultaneously.
* “MAIN” appears for a few seconds when SYSTEM POWER
or STANDBY is pressed.
■ Special considerations for DTS software
The DTS signal is a digital bitstream. If you attempt to
send the DTS signal to the second/third room you will
only hear digital noise (that may damage your speakers).
Thus, the following considerations and adjustments need
to be made when playing DTS encoded discs.
For DVDs encoded with DTS
Only 2 channel analog audio signals may be sent to the
second/third room.
Use the disc menu to set the DVD player’s mixed 2-
channel left and right audio outputs to the PCM or Dolby
Digital soundtrack.
For CDs encoded in DTS
To avoid unexpected noise, DO NOT USE the Zone 2/
Zone 3 feature with CDs encoded in DTS.
Notes
DTV DVR/VCR2 VCR 1 DVD
V-AUX CBL/SAT MD/TAPE CD-R
PHONO TUNER CD MULTI CH IN
POWER POWER POWER SYSTEM STANDBY
AV TV
SLEEP INPUT MODE A B
SET MENU
MENU
PURE DIRECT LEVEL
TITLE
A / B / C / D / E
SELECT
VOL
+
–
CH
+
–
TV VOL
TV MUTE TV INPUT MUTE
+
–
AMP
SOURCE
TV
*
LCD display
SYSTEM POWER/
STANDBY
Normal mode * Name of component
Turns the main unit
on/standby
Zone 2 mode
“ZONE2” or “2:name
of component” Turns Zone 2 to on/
standby
Zone 3 mode
“ZONE3” or “3:name
of component” Turns Zone 3 to on/
standby
System mode “SYSTM”
Turns everything (the
main unit, Zone 2,
Zone 3) on/standby
01EN00_HTR5890U.book Page 79 Thursday, December 23, 2004 12:39 PM