Yamaha htr-5890 - Manual (Page 49)

RECORDING
45
BA
S
IC
OPERA
T
ION
Recording adjustments and other operations are
performed from the recording components. Refer to the
operation instructions for those components.
1
Turn on the power of this unit and all
connected components.
2
Select the source component you want to
record from.
3
Start playback (or select a broadcast station)
on the source component.
4
Start recording on the recording component.
y
Always do a test recording before you start an actual recording.
• When this unit is set in the standby mode, you cannot record
between other components connected to this unit.
• The setting of TONE CONTROL, VOLUME, SPEAKER
LEVEL (page 57) and programs does not affect recorded
material.
• A source connected to the MULTI CH INPUT jacks of this unit
cannot be recorded.
• S-video and composite video signals pass independently
through this unit’s video circuits. Therefore, when recording or
dubbing video signals, if your video source component is
connected to provide only an S-video (or only a composite
video) signal, you can record only an S-video (or only a
composite video) signal to your VCR.
• Digital signals input to the DIGITAL INPUT jacks are not
output to the analog AUDIO OUT (L/R) jacks for recording.
Likewise, analog signals input to the AUDIO IN (L/R) jacks are
not output to the DIGITAL OUTPUT jack. Therefore, if your
source component is connected to provide only digital (or
analog) signals, you can only record digital (or analog) signals.
• A given input source is not output on the same REC OUT
channel. (For example, the signal input from VCR 1 IN is not
output on VCR 1 OUT.)
• Check the copyright laws in your country to record from
records, CDs, radio, etc. Recording of copyrighted material may
infringe copyright laws.
■ Special considerations when recording
DTS software
The DTS signal is a digital bitstream. Attempting to
digitally record the DTS bitstream will result in noise
being recorded. Therefore, if you want to use this unit to
record sources that have DTS signals recorded on them,
the following considerations and adjustments need to be
made.
For DVDs and CDs encoded with DTS, when your player
is compatible with the DTS format, follow its operation
instruction to make a setting so that the analog signal will
be output from the player.
RECORDING
PRESET/TUNING
EDIT
FM/AM A/B/C/D/E PRESET/TUNING
INPUT MODE TONE CONTROL MULTI CH INPUT STRAIGHT
EFFECT
MEMORY
MAN'L/AUTO FM
TUNING MODE
AUTO/MAN'L MONO
VOLUME
PROGRAM INPUT
STANDBY /ON
OPTIMIZER MIC
PHONES
SILENT CINEMA
SPEAKERS A B
OPTICAL R AUDIO L VIDEO S VIDEO
VIDEO AUX
PURE DIRECT
1 2
DTV DVR/VCR2 VCR 1 DVD
V-AUX CBL/SAT MD/TAPE CD-R
PHONO TUNER CD MULTI CH IN
POWER POWER POWER SYSTEM STANDBY
AV TV
SLEEP INPUT MODE A B
1
2
DTV DVR/VCR2 VCR 1 DVD
V-AUX CBL/SAT MD/TAPE CD-R
PHONO TUNER CD MULTI CH IN
INPUT
or
Front panel Remote control
Notes
If you playback a video source that uses scrambled or
encoded signals to prevent it from being dubbed, the
picture itself may be disturbed due to those signals.
01EN00_HTR5890U.book Page 45 Thursday, December 23, 2004 12:39 PM