D) graphic eq, D)graphic eq, E)lfe level – Yamaha htr-5890 User Manual
Page 62: F)dynamic range, Graphic equalizer, Low-frequency effect level, Dynamic range
58
SET MENU
■
Graphic equalizer
D)GRAPHIC EQ
Use this feature to select parametric (PEQ) or graphic
equalizer (GEQ).
Equalizer select
EQ SELECT
Choices: PEQ, GEQ
• Select “PEQ” to use the equalizer adjusted in auto
setup.
• Select “GEQ” to adjust the built-in 7-band graphic
equalizer (see “Equalizer” below).
Equalizer
Use to match the tonal quality of the center, surround L/R
and surround back L/R speakers with that of the front L/R
speakers.
Choices: –6 to +6 (dB)
You can adjust 7 frequency bands: 63Hz, 160Hz, 400Hz,
1kHz, 2.5kHz, 6.3kHz, 16kHz
■
Low-frequency effect level
E)LFE LEVEL
Use to adjust the output level of the LFE (low-frequency
effect) channel according to the capacity of your
subwoofer or headphones. The LFE channel carries low-
frequency special effects which are only added to certain
scenes. This setting is effective only when this unit
decodes Dolby Digital or DTS signals.
Choices: –20 to
0
(dB)
Speaker
SPEAKER
Select to adjust the speaker LFE level.
Headphone
HEADPHONE
Select to adjust the headphone LFE level.
Depending on the settings of LFE LEVEL, some signals may not
be output from the SUBWOOFER PRE OUT jack.
■
Dynamic range
F)DYNAMIC RANGE
Use to select the amount of dynamic range compression to
be applied to your speakers or headphones. This setting is
effective only when the unit is decoding Dolby Digital and
DTS signals.
Choices: MIN (minimum), STD (standard),
MAX
(maximum)
Speaker
SP
Select to adjust the speaker compression.
Headphone
HP
Select to adjust the headphone compression.
• Select “MIN” if you regularly listen at low volume
levels.
• Select “STD” for general use.
• Select “MAX” to preserve the greatest amount of
dynamic range.
Note
. EQ SELECT....PEQ
/
: Up/Down
p
p
> : Select
D) GRAPHIC EQ
. CHANNEL;;FRONT L
-
+
63Hz
0dB
160Hz
0dB
400Hz
0dB
1kHz
0dB
2.5kHz
0dB
6.3kHz
0dB
16kHz
0dB
D)GRAPHIC EQ
. SPEAKER;;;;;;0dB
HEADPHONE;;;;0dB
/
: Up/Down
p
p
> : Adjust
E)LFE LEVEL
. SP: MIN STD[MAX
HP: MIN STD[MAX
/
: Up/Down
p
p
> : Select
F)DYNAMIC RANGE
01EN00_HTR5890U.book Page 58 Thursday, December 23, 2004 12:39 PM