Xerox 1075 User Manual
Page 44
Installing the Printer Driver and Software
38
2
❖
❖
❖
❖ When connecting with the network
• The machine must be set to bidirectional transmission.
• SmartNetMonitor for Client included on the CD-ROM must be installed.
One of the following conditions must also be satisfied besides the two re-
quirements mentioned above.
• The port for SmartNetMonitor for Client and the TCP/IP protocol must be
used.
• The standard TCP/IP port is used without changing the port name (Win-
dows 2000/XP).
• The IP address specified in the Microsoft TCP/IP Print is used (Windows
NT 4.0).
• The IP address is included in port name when using IPP protocol.
Note
❒ In Windows 95/98/Me, [Enable bi-directional support for this printer] must be
selected in [Spool Settings] on the [Details] tab in RPCS™ printer driver.
❒ In Windows 2000/XP, or Windows NT 4.0, [Enable bidirectional support]
must be selected, and [Enable printer pooling] must not be selected on the
[Port]
tab in RPCS™ printer driver.
❖
❖
❖
❖ When connecting with IEEE 1394
• The port on the optional IEEE 1394 Interface Board and the IEEE 1394 port
on the computer are connected using an interface cable (Windows Me,
Windows 2000/XP).
Note
❒ [SCSI print (SBP-2)] must be set to “Active” and [Bidirectional SCSI print] must
be set to “On” in [IEEE 1394] on the [Interface Settings] tab in the machine's
System Settings.
❒ In Windows Me, [Enable bi-directional support for this printer] must be selected
in [Spool Settings] on the [Details] tab in RPCS™ printer driver.
❒ In Windows 2000/XP, or Windows NT 4.0, [Enable bidirectional support]
must be selected, and [Enable printer pooling] must not be selected on the
[Port]
tab in RPCS™ printer driver.
❖
❖
❖
❖ When connecting with USB2.0
• The port on the optional USB2.0 Interface Board and the USB port on the
computer are connected using a USB interface cable (Windows 98SE/Me,
Windows 2000/XP).
Note
❒ In Windows 98SE/Me, [Enable bi-directional support for this printer] must be
selected in [Spool Settings] on the [Details] tab in RPCS™ printer driver.
❒ In Windows 2000/XP, [Enable bidirectional support] must be selected, and
[Enable printer pooling]
must not be selected on the [Port] tab in RPCS™
printer driver.