Xerox 1075 - Manual (Page 21)

Setting Paper on the Bypass Tray
15
1
AAAA
Open the bypass tray.
BBBB
Adjust the paper guides to the paper size.
Important
❒ If the paper guides are not flush against the paper, skewed images or paper
misfeeds might occur.
CCCC
Gently insert the paper face up in the bypass tray until the beeper sounds.
1. Extender
2. Paper guides
Note
❒ Be sure to set paper in L orientation as shown in the illustration above.
❒ The beeper will not sound if it is turned off. Gently insert the paper until it
stops.
❒ Do not stack paper over the limit mark, otherwise a skewed image or paper
misfeeds might occur.
❒ Open out the extender to support paper sizes larger than A4 L , 8 1 /
2
"
×11" L .
❒ Fan the paper to get air between the sheets to avoid a multi-sheet feed.
❒ When setting an OHP transparency, make sure that its front and back sides
are properly positioned.
❒ Select the paper type when printing on OHP transparencies or thick paper
(over 105g/m 2 ). For details, see p.18 “Setting thick paper or OHP transpar-
encies”.
ZGUH030E
ZGWH071E
2
1