Routing - static route, Routing – static route – Zhone Technologies 6212-I2 User Manual
Page 58
Advanced Setup
58
6212-I2 4-Port Router User’s Guide
6212-A2-ZB23-10
If you want to specify the default gateway address, then uncheck the box as
seen below. Enter the default gateway address and, optionally, the WAN
interface you will use. Click on Save / Apply to save the settings.
If you add or change the default gateway address, you must reboot the router
to put the new default gateway IP address into effect.
Figure 62: Default Gateway Setup
Routing – Static Route
Use the Routing - Static Route screen to add a static route to the routing table.
Figure 63: Static Route Setup
Enter the route information and click on Save/Apply to make it active. No
reboot is required.
See also other documents in the category Zhone Technologies Hardware:
- IPD 12000E (3 pages)
- 6652-A1 (2 pages)
- 600 (240 pages)
- Raptor-XP-15x (4 pages)
- 1754-A1-XXX (2 pages)
- 900 (176 pages)
- 2110 (7 pages)
- 6411 (2 pages)
- 6382-A1-xxx (2 pages)
- 6412-A1-xxx (2 pages)
- 6610-A1-xxx (2 pages)
- 4000E (22 pages)
- 08-01002-01 (32 pages)
- 6210 (1 page)
- 6218-I2-xxx (2 pages)
- BITSTORM HP-150 (4 pages)
- 800 (138 pages)
- ZTI-PG (16 pages)
- Raptor ATM (4 pages)
- ADSL2+ Reach & High Performance (2 pages)
- MALC-XP (4 pages)
- 6211-I3-xxx (2 pages)
- IMACS Network Device (114 pages)
- 1611-A2-xxx (2 pages)
- 5620 (20 pages)
- 6213 (84 pages)
- 6381-A3-xxx (2 pages)
- 6381-A3 (2 pages)
- 6218-I2 (94 pages)
- 6411-A1-xxx (2 pages)
- 1612-A2-xxx (2 pages)
- Copper-Based Ethernet (8 pages)
- zPON (4 pages)
- 6388-A1-XXX (2 pages)
- 4800 Express (2 pages)
- 6238-I2 (79 pages)
- 6228-I2-xxx (2 pages)
- 6218-13 (2 pages)
- 6652-A2 (2 pages)