ZyXEL Communications PLA-4xx Series - Manual (Page 43)

Chapter 4 Powerline Network Setup Tutorial
PLA-4xx Series User’s Guide
43
3 To set up a new powerline network, type the DAK Password and change the Network
Name on all powerline adapters you wish to add to your network.
• Look for the DAK Password on a label on your powerline adapter. The DAK
Password lets you access the adapter.
• Select the Remote adapter you want to add (A) and type the DAK Password in
the DAK Password field (B).
• Then type the new network name in the Network Name field.
Figure 28 Adding an Adapter to Your New Network
4 Click Save.
• If you do not type the DAK password or type it incorrectly either of the following pop-
ups appears. Click OK and type the DAK Password correctly in the DAK Password
field.
Figure 29 Incorrect DAK or No DAK
• If you have correctly entered the DAK Password, click OK on the pop-up.
Figure 30 Correct DAK
5 The settings for the adapter will now grey out and the adapter will disappear from the
table after a few minutes.
B
A