Yamaha D5000 - Manual (Page 30)

28 - How to initialize the D5000
D5000
How to initialize the D5000
You can reset all programs and system parameters back to their original factory settings with the
following procedure:
• While pressing the [ < ] "
STORE " CURSOR key, turn the power on.
• The LCD will display the message " Press [RECALL] to initialize ".
• Press the [ > ] "
RECALL " CURSOR key. The message " Initializing now... " will
momentarily appear on the LCD. Then the D5000 will default to Program Select Mode.
Error Messages
WARNING PLEASE BE CERTAIN THAT THIS IS WHAT YOU INTEND TO DO. Any custom programs you
have created will be lost when the D5000 is reset to its factory settings.
WARNING LOW BATTERY The voltage of the internal lithium battery has dropped below a
serviceable level. Take the unit to a qualified Yamaha service
center to have the battery replaced.
WARNING DATA ERROR When the internal lithium battery is exhausted, the contents of the
internal memory will be lost. Take the unit to a qualified Yamaha
service center to have the battery replaced.
E0 ~ E3 When the power is turned on, the D5000 performs a self-test
diagnostic. If any faults are discovered, one of the error numbers
E0 to E3 will be displayed on the PROGRAM LED. Take the unit
to a qualified Yamaha service center for repair. Do not forget the
error number – the service technician needs that number in order
to speed up diagnosis of your unit.