Yamaha D5000 - Manual (Page 27)

Utility Mode - 25
D5000
MIDI CONTROLLER
Each D5000 program (except for Sample and Hold programs) can accept input from two MIDI
controllers. These parameters allow you to assign a MIDI controller number to the controller
channels of the programs (see page 12).
MIDI CONTROLLER parameters
MIDI BULK DUMP
BULK DUMP parameters
Press the
[ UTILITY ] key to select the MIDI CONTROLLER command.
Use the [ ^ ] and [ % ] CURSOR keys to move through the various
parameters. Modify the selected parameter by rotating the DATA ENTRY
encoder.
CONTROLLER ( OFF , 1 ~ 31 ,
64 ~ 95 , KEY NOTE ,
KEY VEL. , CH PRES. )
Set a controller number for each controller assignment (1 and 2).
Control change number: 01 MOD.WHEEL
02 BREATH
•
•
•
95
<< KEY NOTE
<< KEY VEL.
<< CH PRES.
CLK ( OFF / ON ) Enable or disable the MIDI clock. When it is enabled, the clock of
the external MIDI device controls the
TEMPO , delay time,
modulation speed, and other clock based functions.
NOTE If you set both controller assignments to the same MIDI controller number, you can control the
parameters assigned in the program simultaneously.
Press the [ UTILITY ] key to select the MIDI BULK DUMP command.
Use the [ ^ ] and [ % ] CURSOR keys to move through the various
parameters. Modify the selected parameter by rotating the DATA ENTRY
encoder.
ITEM ( ALL / SYSTEM /
PROGRAM / BANK )
Select the bulk data type you want to dump.
NO. ( ALL , Program, or Bank) If the ITEM parameter is set to " PROGRAM ", you can select a
program number from 1 to 00 (100). Otherwise select a bank from
A to G .