Tools and materials – Xantrex Technology XC1524 User Manual
Page 21
Preparing for Installation
975-0187-01-01
1–9
Tools and Materials
To mount and connect the XC Series you need the following tools:
•
10 mm wrench or socket for the DC terminals and ground stud
•
Phillips screwdriver for securing the AC wiring compartment cover
•
power drill
•
drill bit for pilot holes for mounting screws
•
wire stripper
•
manufacturer's recommended crimp tool for any crimp terminals that are being
used
You need the following materials:
•
3 conductor AC input wiring
Use the information in “AC Wiring” on page 1–13 and your local electrical
codes to determine the correct wire and breaker or fuse.
•
AC cable strain relief (if the one included is not sufficient for your local
electrical code requirements)
•
appropriately sized DC cables for each battery, with suitable connectors at the
battery end
•
appropriately sized DC chassis ground (earth) with suitable connectors
•
ring terminals to fit 6 mm (1/4 in.) studs at the charger end
•
DC fuse and disconnect or circuit breaker for each battery bank
•
mounting hardware, 3 mm (#6) corrosion resistant 6 pieces.
•
other means to route and secure AC and DC wiring
XC_Charger_Owner.book Page 9 Friday, August 12, 2005 3:23 PM