Error messages, Dg100, Dg80 – Yamaha DG100-212A User Manual
Page 14: Dg130h
14
Error Messages
If an error occurs during operation, one of the following error message numbers will appear on the display.
E1
:
Motor Drive Error
CAUSE:
The volume knob has not returned to its assigned position after 20 seconds has elapsed from the start of the recall
operation or, the device does not recognize the recall command.
SOLUTION:
Turn off the power and return the device to the music dealer where you purchased it, or to the nearest Yamaha Service
Center for repair.
E2
:
MIDI Receive Buffer Full
CAUSE:
Too much MIDI data is being received by the DG amplifier at one time.
SOLUTION:
Try reducing the amount of data being sent or, break the data into smaller blocks.
E3
:
Communication Error.
CAUSE:
An abnormality is detected during MIDI communications.
SOLUTION:
Check all connections, etc. and try again.
E4
:
Bulk Receive Check Sum Error.
CAUSE:
The check sum does not match the received MIDI bulk data.
SOLUTION:
Check all connections and data, and try again.
E5
:
Bulk Receive Data Abnormality.
CAUSE:
An abnormality is detected in the received MIDI bulk data.
SOLUTION:
Check all connections and data, and try again.
E6
:
Backup Battery Error.
CAUSE:
Backup battery power is depleted.
SOLUTION:
Continued use of the device will result in the loss of data. Return the device to the music dealer where you purchased it
or, the nearest Yamaha Service center and have the battery replaced.
DG100-
212A
/DG80-
210A
/DG80-
112A
/DG130H
A