Yamaha DSP-A595a - Manual (Page 35)

35
English
You can use the remote control to control not only this unit but also other components connected to it. The remote control is factory
set to control this unit and most YAMAHA audio components.
To control other brands of components, you must preset the remote control with the manufacturers’ codes listed from
page 310.
2
Press the desired operation button.
Note: Press the button with the remote control aimed at
the front panel.
REMOTE CONTROL
Basic operation
1
Select the position for the component that you want to
control by turning the SELECTOR DIAL.
Note: Turn the SELECTOR DIAL until it stops with a click.
Components which can be controlled
There are nine positions that you can select to control connected components with this remote control. When turning the
SELECTOR DIAL, the position changes as follows:
SELECTOR
DIAL
Notes
1.
The shaded positions in the diagram above indicate that you can preset the code for the manufacturer of your component.
Note that you can preset only one code for one position. (See “SETUP CODES” on page 41 for details).
2. DVD/LD and DVD MENU positions:
• Be sure that the SELECTOR DIAL is set to the DVD/LD position before presetting the code for a DVD or an LD player. The
code that you preset to the DVD/LD position is also simultaneously preset to the DVD MENU position. You cannot preset the
code for a DVD player when the SELECTOR DIAL is set to the DVD MENU position.
• DVD MENU operations cannot be performed for some DVD players.
3. When using a second (and third) VCR (See “To use a second (and third) VCR” on page 41 for details.):
• If you are not using a CBL/DBS (cable TV or DBS tuner), the second (or third) VCR can be preset by using the CBL/DBS
position.
• If you are not using a DVD player, the second (or third) VCR can be preset by using the DVD MENU position. Note that in
this case you must preset the code for an LD player to the DVD/LD position even if an LD player is not being used.
4. The button functions on the remote control differ depending on the position selected by the SELECTOR DIAL. Refer to the
following pages for details.
DVD/LD & DVD MENU:
An LD player can be controlled by using the DVD/LD position.
A DVD player can be controlled by using the DVD/LD and
DVD MENU positions. The code for a YAMAHA DVD player is
preset. If the remote control will not operate your YAMAHA
DVD player, you need to preset code number “4490.”
AMP/TUN:
You can perform basic operations of
this unit and control a YAMAHA
tuner with the SELECTOR
DIAL set to this position. TAPE/MD:
The code for a YAMAHA tape deck is preset.
(Be sure to preset the proper code when operating a YAMAHA
MD recorder.)
CD:
The code for a YAMAHA CD player is preset.
DSP:
This unit can be controlled and DSP programs can be selected
directly.
VCR:
A VCR can be controlled.
CBL/DBS:
A cable television or
DBS tuner can be
controlled.
TV:
A television can be
controlled.
Indicator
The indicator will flash when the button is
pressed.
The position name is displayed
in this window.
01DSP-A595a-6 6/24/99, 12:15 PM 35