Yamaha DSP-A595a - Manual (Page 34)

34
C.DELAY [Adjusting the delay of
center sounds (dialog, etc.)]
Control range: 0 ms to 5 ms (in 1 ms steps)
Preset value: 0 ms
* This adjustment is effective only when Dolby Digital or DTS is
being decoded and the signals of the selected source
encoded with Dolby Digital or DTS contain center-channel
signals.
This adjusts the delay between the main sound (on the main
channels) and dialog, etc. (on the center channel).
The larger the value, the later the dialog, etc. is generated.
This is for making sounds from the left main, center and right
main speakers reach your listening position at the same time.
This is achieved by delaying the sound from the center speaker
if the distance from the center speaker to your listening position
is shorter than the distance from the left or right main speaker
to your listening position.
GUARD (Memory guard)
Choices: ON/OFF
Preset position: OFF
If you wish to prevent accidental alterations to SET MENU and
other adjustments on this unit, select ON. The following
functions on this unit can be locked by this operation:
• Other functions in the SET MENU mode
• Functions in the TIME/LEVEL mode
• Functions when using TEST
INPUT
(Selecting the mode of the TV/DBS input)
Choices: AUTO/LAST
Preset position: AUTO
You can designate the input mode that is automatically selected
when the power of this unit is switched on for only the sources
connected to the TV/DBS input terminals of this unit.
AUTO: In this position, the AUTO input mode is always
selected when the power for this unit is switched on.
LAST: In this position, the input mode you selected last time
is memorized and will not be changed when the
power is switched on again.
* See page 25 for details on switching the input mode.
Adjustment method
Adjustments should be made while watching the information on
this unit’s display.
When adjusting with the remote control, set the SELECTOR
DIAL to the AMP/TUN or DSP position on the remote control.
or
Press SET MENU once or more so that the function which you
want to change appears on the display.
Front panel Remote control
or
* After pressing SET MENU once on the remote control, you
can also select the title by pressing . (Pressing goes back
one selection.)
Press + or – to select any desired position or to edit parameters
of the chosen function.
Front panel Remote control
or
Repeat these steps to change or adjust the settings of any
other function.
Memory back-up
The memory back-up circuit prevents the stored data from
being lost when this unit is set in the standby mode. If,
however, the power plug is disconnected from the AC outlet or
the power is cut due to temporary power failure for more than
one week, the settings of the SET MENU mode will automati-
cally return to the factory settings. If so, they can be re-set by
simply following the procedure above.
01DSP-A595a-5 6/24/99, 12:15 PM 34