Xerox Trimmer Module SquareFold - Manual (Page 20)

SquareFold Trimmer User Guide 16
Problem solving
Fault code Possible cause Recommended solution
E303
E304 A top cover is open. Open the Top Left and Right Covers of the SquareFold
Trimmer Module. 1.
2. Close the SquareFold Trimmer Module Top Left and Right
Covers.
E308
E940
E941 The Trimmer Waste Container is full or
has a fault. Pull open the container and empty any trimmer scraps from
it. 1.
2. Reinsert the container into the SquareFold Trimmer Module.
Ensure that the container is fully pushed in, and that the
indicator light is not lit. 3.
If fault persists, call for service. 4.
If fault persists, repeat Steps 1-3. 4.
If fault persists, power off/on the copier/printer. 5.
If fault persists, power off/on the copier/printer. 3.
If fault persists, call for service. 6.
E943 Booklet Tray on the SquareFold
Trimmer Module is full. Remove any booklets from the tray. 1.
If fault persists, power off/on the copier/printer. 2.
If fault persists, call for service. 3.