Xerox Trimmer Module SquareFold - Manual (Page 10)

SquareFold Trimmer User Guide 6
Overview
1.
2.
3.
4.
5.
The Square Fold Settings are found on the SquareFold
Trimmer Module control panel. The settings can be switched
on or off based on user preference. When the settings are
switched on, you can select one of five options depending on
your requirements for the finished booklet job:
+2: Use this setting when you want the most amount of
pressure applied to the spine of the booklet. The more
pressure applied to the booklet, the more square the booklet
spine will be. +2 is the greatest amount of pressure that can
be applied to the booklet.
Additionally, you may want to select this setting when your
finished booklet is five pages or less and on heavier weight
paper (200 g/m² or greater).
+1: Use this setting when you want a greater amount of
pressure applied to the spine of the booklet, but not as much
pressure as the +2 setting uses.
Square Fold Settings
5.
4.
3.
2.
1.
Auto: This is the machine default setting and is used for
most jobs.
-1: Use this setting when you want less pressure applied to
the spine of the booklet. The less pressure applied to the
booklet, the more rounded the booklet spine will be.
-2: Select this setting when your finished booklet is five pages
or less and on lighter weight paper (100 g/m² or lower). -2 is
the least amount of pressure that can be applied to the
booklet.
Choose the setting that best fits your needs for the booklet
output.
Note: You may want to run one or more test prints/copies
before running larger jobs.