Yamaha CDX-490 - Manual (Page 17)

17
English
1
Follow steps 1 – 4 on page 15.
2
* The unit will automatically program tracks for side A and
side B separately considering the tape’s total time.
3
Begin recording on the tape deck and press the PLAY
button on this unit at the same time.
4
The unit will pause at the end of side A of the tape.
Turn the tape over to side B. Resume recording and, at
the same time, press the PLAY or PAUSE button on
this unit.
Notes
• Because the programmed data changes every time the
RANDOM button is pressed, the amount of time remaining
at the end of the tape also changes accordingly.
• If the tape’s length is not enough, all tracks cannot be
programmed. In this case, exchange the tape for a longer
one.
• In step 2, you can check the program data for side A and
side B.
➀ Shows the number of programmed tracks for each side in
turn just after the automatic programming is finished, and
then it is replaced by the number of the first programmed
track for side A.
➁
Shows the total time of programmed tracks for each side.
➂
Shows the side of the tape.
➃
Shows the programmed track numbers for each side.
• CD synchronized recording function can be used if your
tape deck is compatible with it. If so, in step 3 and 4, press
the SYNCHRO button and then press the PLAY button on
this unit’s remote control transmitter. Recording
automatically begins. (For details, refer to page 19.)
Ⅲ
Random sequential tape-programming
The unit will automatically program tracks in random sequential order for recording to tape.
PROGRAM
A
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20
TOTAL
➀ ➁
➃ ➂
RANDOM
2 1
SPACE TAPE PEAK
SYNCHRO
3 INDEX
PROG CLEAR
OPEN/
CLOSE
8 7 9 0
5 4 6 + I0
DIMMER TIME
REPEAT RANDOM
SEARCH
SKIP OUTPUT LEVEL – +
STOP PAUSE PLAY
4
2
3, 4