Yamaha CDX-490 - Manual (Page 16)

1
Follow steps 1 – 4 on page 15.
2
3
Program desired tracks (to be recorded on side A) in
any desired order.
* Programmed track numbers light up on the display. You
can select a track which can be programmed for the
remaining time of (the side of) the tape from track
numbers flashing on the display, but you cannot select a
track number extinguished from the display.
4
When track selection for side A is finished, press the
TAPE button.
5
Select the track numbers (to be recorded on side B) in
any desired order.
6
Begin recording on the tape deck and press the PLAY
button on this unit at the same time.
7
The unit will pause at the end of side A of the tape.
Turn the tape over to side B. Resume recording and,
at the same time, press the PLAY or PAUSE button on
this unit.
Notes
• If, in step 3 or 5, “E rr” appears on the display, the track
number just selected cannot be programmed because there
is not enough time remaining on the tape. However, at this
time, if any other track number is flashing continuously on
the display, you can program it instead of the
unprogrammable one.
• In step 3 or 5, each time a selection is made, the track
number and the tape’s remaining time will be displayed, and
then the display will change to indicate the next program
number.
• CD synchronized recording function can be used if your tape
deck is compatible with it. If so, in step 6 and 7, press the
SYNCHRO button and then press the PLAY button on this
unit’s remote control transmitter. Recording automatically
begins. (For details, refer to page 19.)
16
Notes on tape programming
• To check, cancel or correct program data, refer to page 14.
* In checking the program data, note that “Pu” appears
between track numbers for side A and side B.
• Up to a maximum of 25 tracks can be programmed. If,
however, the PAUSE mode is inserted, it is counted as one
track.
• This function can be used to program up to track number 24.
If the disc has more than 24 tracks, track number 25 and
thereafter will not be programmed.
Ⅲ
Manual tape-programming
This is for recording desired tracks in any desired
order onto a tape.
PROG
PROGRAM
A
1 2 3 4 5 6 7 8 9 10 11 12
TOTAL
REMAIN
TAPE
2 1 3
8 7 9 0
5 4 6 + I0
2 1 3
8 7 9 0
5 4 6 + I0
2 1
SPACE TAPE PEAK
SYNCHRO
3 INDEX
PROG CLEAR
OPEN/
CLOSE
8 7 9 0
5 4 6 + I0
DIMMER TIME
REPEAT RANDOM
SEARCH
SKIP OUTPUT LEVEL – +
STOP PAUSE PLAY
A pause mode is programmed.
3, 5
2
4
7
6, 7