Weider WESY92190 - Manual (Page 6)

6
1. Before beginning assembly, make sure you have
read and understood the information on page 5.
Open the parts bag labeled ÒFRAME ASSEMBLY.Ó
Press a 2Ó Square Outer Cap (51) onto each end of
the Stabilizer (5).
Insert two 5/16Ó x 2 3/4Ó Carriage Bolts (14) up
through the Stabilizer (5) and place it flat on the floor.
1
2. Press a 2Ó Square Inner Cap (21) into the end of the
Base (8).
Insert two 5/16Ó x 2 1/2Ó Carriage Bolts (52) up
through the Base (8).
Place the Base (8) on the floor with the holes in the
mounting bracket over the Carriage Bolts (14) in the
Stabilizer (5).
2
Frame Assembly
51
51
14
5
21
8
52
14
5
Bracket
3. Press a 1Ó x 2Ó Inner Cap (11) into the top of the Rear
Upright (18).
Slide the Rear Upright (18) onto the 5/16Ó x 2 3/4Ó
Carriage Bolts (14) in the Stabilizer (5). Hand tighten
a 5/16Ó Nylon Locknut (53) onto each Carriage Bolt.
Make sure the Rear Upright (18) is oriented as
shown. The wide side of the bracket on the lower
end must be on the side shown.
Slide the Front Upright (42) onto the 5/16Ó x 2 1/2Ó
Carriage Bolts (52) in the Base (8). Hand tighten a
5/16Ó Nylon Locknut (53) onto each Carriage Bolt.
Do not tighten the Nylon Locknuts yet.
3
53
53
53
Wide
Side of
the
Bracket
52
11
5
8
18 42
14
53