Weider WESY92190 - Manual (Page 11)

11
19. Remove the 1/2Ó Nylon Locknut (68) from the welded
hook on the Top Frame (1). Slide the Pulley Bracket
(20) onto the hook and secure it with the Nylon
Locknut. Tighten the Nylon Locknut, but make sure
the Pulley Bracket can pivot freely.
Remove the Pulley (35) from the Pulley Bracket (20).
Wrap the High Cable (2) around the Pulley in the
direction shown.
Re-attach the Pulley (35) to the Pulley Bracket (20)
with the 3/8Ó x 1 1/2Ó Bolt (60) and the 3/8Ó Nylon
Jamnut (63).
Welded
Hook
60
1
18. Move to the other side of the unit. Wrap the High
Cable (2) around a ÒVÓ-Pulley (6) in the direction
shown.
Attach the ÒVÓ-Pulley (6) and a Long Cable Trap (50)
to the Right Butterfly Arm (48) with a 3/8Ó x 2 1/2Ó Bolt
(96) and a 3/8Ó Nylon Locknut (57).
Make sure the Long Cable Trap (50) is positioned
as shown. It may be helpful to take the Butterfly
Arm (48) through one full range of motion to
ensure that the Cable Trap does not rub on the
cable.
18
6
2
48
50
96
57
20. Move to the other side of the unit. Remove the pre-
assembled 3 1/2Ó Pulleys (35) attached to the Pulley
Plates (31).
Wrap the High Cable (2) around the 3 1/2Ó Pulley (35)
in the direction shown.
Re-attach the Pulley (35) and a Cable Trap (66) to
the indicated holes in the Pulley Plates (31) with the
3/8Ó x 1 1/2Ó Bolt (60) and the 3/8Ó Nylon Jamnut (63).
20
60
31
2
63
66
21. Wrap the High Cable (2) around a 3 1/2Ó Pulley (35)
in the direction shown. Attach the Pulley to the brack-
et underneath the Top Frame (1) with a 3/8Ó x 1 1/2Ó
Bolt (60) and a 3/8Ó Nylon Jamnut (63). Make sure
the Bolt is inserted from the direction shown.
21
60
Welded
Bracket
1
2
63
35
19
20
63
68
35
2
35