Weider WESY92190 - Manual (Page 13)

13
26. Move to the other side of the unit. Wrap the Low
Cable (9) around a 3 1/2Ó Pulley (35) in the direction
shown.
Attach the Pulley to the Front Upright (42) with a 3/8Ó
x 3 3/4Ó Bolt (19), a Cable Trap (66), a 3/8Ó Flat
Washer (55) and a 3/8Ó Nylon Jamnut (63).
Make sure the Cable Trap (66) is positioned as
shown and that the Pulley (35) is not rubbing on
the Cable Trap.
26
42
19
63
55
35
9
27. Thread the Low Cable (9) through the Press Frame
(12). Wrap the Low Cable around a 3 1/2Ó Pulley (35)
in the direction shown.
Attach the Pulley (35) to the Press Frame (12) with a
3/8Ó x 3 1/4Ó Bolt (69), a 3/8Ó Flat Washer (55), a
Cable Trap (66) and a 3/8Ó Nylon Locknut (57).
Make sure the Cable Trap (66) is positioned as
shown and that the Pulley (35) is not rubbing on
the Cable Trap.
27
35
12
69
66
57
9
55
29. Wrap the Low Cable (9) around a 3 1/2Ó Pulley (35) in
the direction shown. Attach the Pulley to the Press
Frame (12) with a 3/8Ó x 3 1/4Ó Bolt (69), a 3/8Ó Flat
Washer (55), a Cable Trap (66) and a 3/8Ó Nylon
Locknut (57).
Make sure the Cable Trap (66) is positioned as
shown and that the Pulley (35) is not rubbing on
the Cable Trap.
29
57
69
9
12
55
35
66
28. Wrap the Low Cable (9) around a ÒVÓ- Pulley (6) in
the direction shown. Attach the ÒVÓ-Pulley to the tube
on the Seat Frame (36) with a 3/8Ó x 3 1/4Ó Bolt (69),
a Long Cable Trap (50), a 3/8Ó Flat Washer (55), and
a 3/8Ó Nylon Locknut (57).
Note: The ÒVÓ-Pulley (6) should be attached to the
third hole, counting from the Front Upright (42).
Make sure the Cable Trap (50) is positioned as
shown and that the ÒVÓ-Pulley (6) is not rubbing
on the Cable Trap.
28
36
9
55
57
6
Tube
50
69
42
66