Weider WESY92190 - Manual (Page 10)

Cable Assembly
15. Open the parts bag labeled ÒCABLE ASSEMBLY
AND PULLEYS.Ó For Cable identification and rout-
ing during steps 15Ð30, refer to the Cable
Diagram and Cable ID Chart on page 19.
Identify the High Cable (2). It is approximately 163
1/2Ó long. It is the shortest cable and it has a ball on
each end. Wrap the end with the small ball around a
3 1/2Ó Pulley (35) in the direction shown.
Attach the Pulley (35) to the Top Frame (1) with a
3/8Ó x 3 1/2Ó Bolt (54), a 3/8Ó Flat Washer (55) and a
3/8Ó Nylon Jamnut (63).
Make sure the High Cable (2) is between the
Pulley (35) and the welded hook on the Top Frame
(1).
15
1
63
54
2
55
35
Hook
16. Wrap the High Cable (2) around a ÒVÓ-Pulley (6) in
the direction shown.
Attach the ÒVÓ-Pulley (6) and a Long Cable Trap (50)
to the indicated bracket with a 3/8Ó x 2 1/4Ó Bolt (65)
and a 3/8Ó Nylon Locknut (57). Make sure the Long
Cable Trap is positioned as shown, so it will hold
the Cable in place.
16
Welded
Bracket
65
2
50
6
57
17. Wrap the High Cable (2) around a ÒVÓ-Pulley (6) in
the direction shown.
Attach the ÒVÓ-Pulley (6) and a Long Cable Trap (50)
to the Left Butterfly Arm (47) with a 3/8Ó x 2 1/2Ó Bolt
(96) and a 3/8Ó Nylon Locknut (57).
Make sure the Long Cable Trap (50) is positioned
as shown. It may be helpful to take the Butterfly
Arm (47) through one full range of motion to
ensure that the Cable Trap does not rub on the
cable.
Route the High Cable (2) under the Top Frame (1)
between the ÒVÓ-Pulley (6) and the crossbar.
17
2
6
50
Crossbar
47
1
96
57
10