Weider WESY92190 - Manual (Page 14)

31. Open the parts bag labeled ÒSEAT ASSEMBLY.Ó
Attach the Backrest (41) to the Front Upright (42) with
two 1/4Ó x 2 1/2Ó Screws (43) and two 1/4Ó Flat
Washers (90).
Seat Assembly
41
43
43
90
42
30. Wrap the Low Cable (9) around a 3 1/2Ó Pulley (35) in
the direction shown. Attach the Pulley to the Front
Upright (42) with a 3/8Ó x 3 3/4Ó Bolt (19), a Cable
Trap (66), a 3/8Ó Flat Washer (55), and a 3/8Ó Nylon
Jamnut (63).
Make sure the Cable Trap (66) is positioned as
shown and that the Pulley (35) is not rubbing on
the Cable Trap.
Attach the loop on the end of the Low Cable (9) to the
3/8Ó x 2 1/4Ó Eyebolt (44) with a Cable Clip (73).
Note: Cable Clips are located in the parts bag labeled
ÒSEAT ASSEMBLY.Ó
30
12
9
73
44
19
66
35
42
63
55
32. Insert the 1/4Ó x 2Ó Carriage Bolt (38) into the center
hole in the Seat Plate (37). Attach the Seat Plate to
the Seat (13) with two 1/4Ó x 3/4Ó Screws (17).
Insert the 1/4Ó x 2Ó Carriage Bolt (38) into the indicat-
ed hole in the Seat Frame (36). Tighten a 1/4Ó Nylon
Locknut (89) with a 1/4Ó Flat Washer (90) onto the
Carriage Bolt.
Attach the other end of the Seat (13) to the Seat
Frame (36) with a 1/4Ó Flat Washer (90) and a 1/4Ó x
2Ó Bolt (71).
32
37
17
90
36
13
38
90
71
14
31
89