Watlow EM Gateway - Manual (Page 27)

27
Declaration of Conformity
Gateway Products
Watlow Winona, Inc.
1241 Bundy Blvd.
Winona, MN 55987 USA
Declares that the following product:
Model Numbers: EM00-GATE-0000, NGW0-0000-2400 and NGW0-0000-0000*
Classification: Communications interface card, Installation Category I, Pollution
degree II
Rated Voltage: 24V (ac or dc) or 5V (dc)
Rated Frequency: 50/60 Hz or dc
Rated Power: 10VA maximum
*NGW0-0000-0000 Requires use of a Ferrico NF130 Clamp on ferrite on all lines to pass Class B
emissions. Depending on end use setup, this bead may or may not be necessary.
Meets the essential requirements of the following European Union Directives by using the relevant
standards show below to indicate compliance.
89/336/EEC Electromagnetic Compatibility Directive
EN 61326:1997 With A1:1998 – Electrical equipment for measurement, control and
laboratory use – EMC requirements (Industrial Immunity, Class B Emissions).
EN 61000-4-2:1996 With A1, 1998 – Electrostatic Discharge Immunity
EN 61000-4-3:1997 – Radiated Field Immunity
EN 61000-4-4:1995 – Electrical Fast-Transient / Burst Immunity
EN 61000-4-5:1995 With A1, 1996 – Surge Immunity
EN 61000-4-6:1996 – Conducted Immunity
EN 61000-4-11:1994 Voltage Dips, Short Interruptions and Voltage Variations Immunity
EN 61000-3-2:1995 With A1-3:1999 – Harmonic Current Emissions
EN 61000-3-3:1995 With A1:1998 – Voltage Fluctuations and Flicker
Use of an appropriately approved class 2 power source is required for compliance.
Jim Boigenzahn Winona, Minnesota, USA
Name of Authorized Representative Place of Issue
General Manager February 28, 2002
Title of Authorized Representative Date of Issue
Signature of Authorized Representative