Wayne-Dalton PRODRIVE 3222C-Z - Manual (Page 6)

Table of Contents
Package Contents ..............................................................................I.
Pre-Installation Inspection ............................................................. II, III
Tools Needed ...................................................................................IV.
Important Safety Instructions ............................................................V.
Prodrive ® Installation ..................................................................1-5.
Pre-Operation .............................................................................6-19.
Optional Installations ................................................................20-26.
Operation .................................................................................27-32.
Programing Wireless Wall Station Or Transmitter(s) to Opener ....... 33.
Maintenance .................................................................................. 34.
Troubleshooting ............................................................................. 35.
Parts Breakdown Rail Assembly ..................................................... 36.
Parts Breakdown Opener Assembly ............................................... 37.
Accessories .................................................................................... 38.
Templates ...................................................................................... 39.
Customer Service Number ............................................................. 40.
Warranty ........................................................................................ 41.
Defi nition of key words used in this manual:
INDICATES A POTENTIALLY HAZARDOUS SITUATION WHICH,
IF NOT AVOIDED, COULD RESULT IN SEVERE OR FATAL
INJURY.
CAUTION: PROPERTY DAMAGE OR INJURY CAN RESULT FROM
FAILURE TO FOLLOW INSTRUCTIONS.
IMPORTANT: REQUIRED STEP FOR SAFE AND PROPER OPENER
OPERATION.
NOTE: Information assuring proper installation of the opener .
WARNING
WARNING
INCORRECT INSTALLATION CAN
LEAD TO SEVERE OR FATAL
INJURY. FOLLOW THESE
INSTRUCTIONS CAREFULLY.
IMPORTANT INSTALLATION
INSTRUCTIONS
1. READ AND FOLLOW ALL INSTALLATION INSTRUCTIONS.
2. Do not connect the opener to electrical power until instructed to do so.
3. Install the entrapment warning label next to the wall station in a
prominent location. Install the emergency disconnect label on the
emergency disconnect cord.
4. Remove all ropes and remove, or make inoperative in the unlocked
position, all locks connected to the garage door before installing the
opener.
5. Do not wear rings, watches or loose clothing when installing or servicing
a garage door system.
6. It is important that you install all the components supplied with the
Prodrive ® opener, i.e., wall stations, safety sensors, etc. Use of parts not
supplied by Wayne-Dalton Corp. may cause the opener to malfunction
and create unsafe conditions.
7. Wear protective eye wear when installing or servicing the opener or door.
8. Install opener on a properly balanced and operating garage door. Have a
qualified service person make adjustments/repairs to cables, spring
assemblies, and other hardware before installing the opener. An
improperly balanced door could cause severe or fatal injury.
9. Where possible, install the opener seven feet or more above the floor.
Mount the emergency disconnect six feet above the floor.
10. Locate the wall station: (a) within sight of door, (b) at a minimum height
of five feet, so small children cannot reach it, and (c) away from all
moving parts of the door.
11. After installing the opener, the door must reverse when it contacts a
1-1/2” high object (or 2 x 4 board laid flat) on the floor.
12. Installation and wiring must comply with local building and electrical
codes. Connect the power cord to a properly grounded outlet. Do not
remove the ground pin from power cord.
13. To reduce the risk of injury to persons, use this opener only with
sectional overhead doors.
14. Top section of garage door may need to be reinforced before
attaching opener. Check with your garage door manufacturer for
their recommendations.
15. Do not use sensitivity adjustments to compensate for a poorly
operating door. This will prevent proper operation of the safety
reverse feature and may damage the door and cause possible
severe or fatal injury.
16. An open door must not close and closing door must reverse and open
if infrared safety sensors are obstructed by 6” high object placed on
garage fl oor.
17. Use a sturdy, non-metallic step ladder when installing opener.
AFTER INSTALLATION IS COMPLETE, FASTEN
THIS MANUAL NEAR GARAGE DOOR. PERFORM
OBSTRUCTION TESTS MONTHLY AND
MAINTENANCE AS RECOMMENDED. SEE PAGES
17 & 34.
Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need
You can reach us Toll Free at 1-888-827-3667 for Consumer Assistance or online at www.wayne-dalton.com
V