Wayne-Dalton PRODRIVE 3222C-Z - Manual (Page 28)

Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need
You can reach us Toll Free at 1-888-827-3667 for Consumer Assistance or online at www.wayne-dalton.com
22
Mounting Door Bracket To A
(9100, 9400, 9600, 5120 & 5140 Series Door)
IMPORTANT: WHEN CONNECTING A
TROLLEY TYPE GARAGE DOOR OPENER
TO THE ABOVE LISTED DOORS, A WAYNE-
DALTON OPENER/TROLLEY BRACKET
MUST BE SECURELY ATTACHED TO THE
TOP SECTION OF THE DOOR, ALONG WITH
ANY U-BARS PROVIDED WITH THE DOOR.
THE INSTALLATION OF THE OPENER MUST
BE ACCORDING TO MANUFACTURER’S
INSTRUCTIONS AND FORCE SETTINGS
MUST BE ADJUSTED PROPERLY.
Locate the center of the top section and seat
the door bracket on male part of the top
section. The door bracket must be centered
and positioned on top section so it bridges
the transition point of the section thickness,
as shown in FIG. 1.1 and 1.2. Install (2) #12
x 1/2” phillips head screws on the opposite
side of door bracket, as shown in FIG. 1.3. If
initially supplied ubar is on the door,
clamp
door bracket to u-bar , as shown in FIG. 1.4.
First attach (3) 1/4” - 14 x 5/8” self-tapping
screws to the door bracket, as shown in
FIG. 1.5. Then attach (2) 1/4” - 14 x 5/8”
self-tapping screws to the door bracket, as
shown in FIG. 1.6.
Remove vice clamps.
NOTE: If you have a 9100 door, you can use
two of the 1/4” - 20 x 11/16” self-drilling
screws used to attach the u-bar instead of
the
1/4” - 14 x 5/8” self-tapping screws
when attaching door bracket to u-bar, as
shown in FIG. 1.6.
NOTE: When attaching door bracket to top
section with u-bar, apply additional pressure
to thread fasteners into the u-bar.
NOTE: See FIG. 1.7 for installing door
bracket on top section without u-bars.
NOTE: After completing this step, continue
with Step 7.
FIG. 1.1
FIG. 1.3
FIG. 1.5
FIG. 1.2
FIG. 1.4
FIG. 1.6
Tools Needed:
Power Drill
7/16” Socket
Driver
Vice Clamps
Phillips Head
Screwdriver
U-BAR
U-BAR
U-BAR
I
Door Bracket
Align Tab With Center
Line Of Top Section
Top Section With Or
Without U-Bar
Opposite Side Of
Door Bracket
(2) #12 x 1/2”
Phillips Head Screws
Door Bracket
Vice Clamp
NOTE: Not Required
For J-Struts
(3) 1/4”-14 x 5/8”
Self Tapping Screws
(2) 1/4”-14 x 5/8”
Self Tapping Screws
(2) 1/4”-20 x 11/16”
Self Drilling Screws
Door Bracket
Door Bracket
Door Bracket
(5) 1/4”-14 x 5/8”
Self Tapping Screws
Male Part Of Top
Section
Door Bracket
Fig. 1.7 Top Section Without U-Bar