Wayne-Dalton PRODRIVE 3222C-Z - Manual (Page 33)

Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need
You can reach us Toll Free at 1-888-827-3667 for Consumer Assistance or online at www.wayne-dalton.com
27
IMPORTANT SAFETY INSTRUCTIONS
TO REDUCE THE RISK OF SEVERE
INJURY OR DEATH:
1. READ AND FOLLOW ALL INSTRUCTIONS.
2. Never let children operate or play with the door controls.
Keep remote controls away from children.
3. Always keep a moving door in sight and keep people and objects
away until it is completely closed. NO ONE SHOULD CROSS THE
PATH OF A MOVING DOOR.
4. NEVER GO UNDER A STOPPED, PARTIALLY OPEN DOOR.
5. Test the Door/Opener monthly. The garage door MUST reverse on
contact with a 1-1/2 inch high object (or a 2 x 4 board laid flat) on the
floor. The door MUST also reverse when a 6” high object is placed on
the floor in line with safety sensors. If Door/Opener fails these tests,
have adjustments/repairs made immediately. Failure to make
adjustments/repairs may cause severe or fatal injury.
6. When possible, use the Emergency Disconnect only when the door is
in the closed position. Be very cautious using the Emergency
Disconnect when the door is open. Weak or broken spring(s) may
allow the door to fall rapidly, causing a severe or fatal injury.
7. KEEP THE GARAGE DOOR PROPERLY BALANCED. See the owner’s
manual included with the door. An improperly balanced door could
cause a severe or fatal injury. Have a qualified service person make
repairs to the cables, spring assemblies, and other hardware.
8.
SAVE THESE INSTRUCTIONS.
Door activation:
Upon activation by either the wall station Up/Down button, transmitter or
wireless keyless entry, the door will move in the following manner:
1. If open, the door will close. If closed, the door will open.
2. If closing, the door will stop. Next activation will open.
3. If opening, the door will stop. Next activation will close.
4. If an obstruction is contacted or the safety sensor beam is
interrupted while closing, the door will reverse and the light will flash.
5. If an obstruction is encountered while opening, the door will stop
and the light will flash. The next activation will close the door.
6. The Infrared Safety Sensor uses an invisible beam which, when
broken by an obstruction, causes a closing door to reverse, prevents
an open door from closing and causes the light to flash.
ALWAYS KEEP MOVING DOOR IN SIGHT AND KEEP PEOPLE AND
OBJECTS AWAY UNTIL IT IS COMPLETELY CLOSED. TO PREVENT A
SEVERE OR FATAL INJURY, AVOID STANDING IN A OPEN DOOR WAY
OR WALKING THROUGH THE DOORWAY WHILE THE DOOR IS
MOVING.
NEVER LET CHILDREN OPERATE DOOR OR PLAY WITH THE DOOR
CONTROLS. KEEP REMOTE CONTROLS AWAY FROM CHILDREN.
FATAL INJURY COULD RESULT SHOULD A CHILD BECOME TRAPPED
BETWEEN THE DOOR AND FLOOR.
KEEP THE GARAGE DOOR PROPERLY BALANCED. AN IMPROPERLY
BALANCED DOOR COULD CAUSE SEVERE OR FATAL INJURY. HAVE A
QUALIFIED SERVICE PERSON MAKE ADJUSTMENTS/REPAIRS TO
CABLES, SPRING ASSEMBLIES, AND OTHER HARDWARE.
Emergency Disconnect:
THE DOOR SHOULD BE FULLY CLOSED WHEN ACTIVATING THE
EMERGENCY RELEASE DISCONNECT. WEAK OR BROKEN SPRINGS
COULD ALLOW AN OPEN DOOR TO FALL RAPIDLY POSSIBLY
CAUSING SEVERE OR FATAL INJURY.
The opener is equipped with an emergency release recessed trolley type
disconnect system, enabling manual operation of the garage door during
power failure. The trolley is disconnected from the chain by pulling down on
the red release knob, allowing the garage door to be operated manually. Do
not use the manual release knob to pull the door open or closed. The trolley
will automatically reconnect when power is restored and door is activated. If
emergency release is used, close door before operating opener.
NOTE: Outside keylock emergency releases are an available accessory and
are recommended for garages without a service entrance.
HOW THE LIGHT WORKS AND WHAT IT MEANS WHEN IT FLASHES:
1. Overhead light automatically turns on when opener is activated and
remains on for 4 minutes for convenience and safety.
2. The light will flash if opener senses an obstruction in the up or
down direction, to warn you of a problem. It will continue flashing for
1 minute, and then shut off.
If the light begins to flash and the door moves a short distance and then
reverses from a wall station button, transmitter or keyless entry, the external
safety sensor device is activated or defective. To temporarily override safety
sensor device and close door, activate wall station up/down button, keeping
button depressed; opener will begin in down direction. The button must
remain depressed until cycle is completed. If the button is released before
cycle is completed, the door will reverse and come to full up position.
Problems in the safety system should be corrected by a qualified service
person.
NOTE: A fully open door with a blinking light indicates an obstruction or
problems with external safety sensors during close travel. See trouble
shooting section on page 35.
WARNING
WARNING
WARNING
WARNING
WARNING
OPERA
TION