Wolf E SERIES SO30-2U/S - Manual (Page 22)

E Series Oven Operation 22
Bake Stone Mode
SETTING CONTROLS
1) Touch STONE.
2) Oven temperature is preset at 400°F (205°C) . Oven
begins to heat after five seconds. To change oven
temperature from 400°F (205°C) , immediately enter
another temperature using the number pads.
3) Touch ENTER to start the cooking mode immediately.
4) Add food when the chime signals that the oven has
reached preheat temperature.
5) If the temperature probe is used, follow temperature
probe feature directions on pages 26–27.
6) If the timer is set, the oven will chime when the cooking
time is finished. If the timer is not cleared, it will
continue to chime every 10 seconds.
7) Remove food. Always use dry pot holders when
removing hot pans from the oven.
8) Touch oven OFF to end this mode.
BAKE STONE ACCESSORY
The bake stone accessory is available through your
authorized Wolf dealer. For local dealer information,
visit the find a showroom section of our website,
wolfappliance.com. Additional use & care information is
provided with the bake stone accessory.
BAKE STONE CARE
Remove excessive food using a scraper. Brush off any
crumbs. Allow the stone to cool completely before wiping
with a wet cloth. Wet cloths on a hot surface can cause
steam burns. Do not soak or immerse the bake stone in
water and do not use soap or detergent. The ceramic
stone could absorb the taste and transmit those flavors to
the food.
Stubborn stains may occur on the bake stone. These will
not impair the flavor of the food being baked.
Allow the bake stone to cool completely before removing
from oven.
IMPORTANT NOTE: Use care in handling the bake stone. It
will chip or break if dropped.
Allow the bake stone to cool completely before wiping
with a wet cloth. Wet cloths on a hot surface can cause
steam burns.